What is DC53 steel?
What is DC53 steel?
DC-53 is a general purpose, cold work die and mold steel that also provides excellent strength and toughness that approaches those of high-speed steels. DC53, is an improvement over alloy tool steel D-2. DC-53 is noted for causing less tool wear and machining times that are faster than D2 Tool Steel.
Is DC53 steel a stainless steel?
All encountered cracking problems. DC53 die steel is the preferred die steel for stainless steel stamping dies.
How to heat treat DC53?
DC53 can be annealed by uniformly heating the part to 800° C (1,475° F) to 850° C (1,550° F), and holding for 2 hours followed by a slow cooling at no more than 27° C (50° F) degrees per hour to until the it has dropped below 500° C (930° F).
What is VG 10 stainless steel?
VG-10 is a cutlery grade stainless steel produced in Japan. The name stands for V Gold 10 (“gold” meaning quality), or sometimes V-Kin-10 (V金10号) (kin means “gold” in Japanese). It is a stainless steel with a high carbon content containing 1% Carbon, 15% Chromium, 1% Molybdenum, 0.2% Vanadium, and 1.5% Cobalt.
What is the hardness of tool steel?
about 60/62 HRC
Hardness in tool steels is most commonly measured using the Rockwell C test. Hardened cold work tool steels are generally about 58/64 HRC (hardness Rockwell C), depending on the grade. Most are typically about 60/62 HRC, although some are occasionally used up to about 66 HRC.
What is D2 steel used for?
D2 tool steel is often used to make blanking dies, cold forming dies, stamping dies, slitters, punches, trim dies and thread rolling dies for applications when exceptional toughness is not necessary.
What is high carbon tool steel?
High carbon tool steel means a high level of carbon in the steel composition. In general high carbon steel contains a Carbon level from 0.60 to 1.00% and containing a manganese level from 0.30 to 0.90%.
Is tool steel malleable?
This is a very versatile, all-purpose tool steel that is characterized by low distortion factor during heat treatment, due to the increased chromium content. This tool steel has good machinability and a balance of wear resistance and toughness.
What do you need to know about dc53 steel?
DC53 steel. DC53 steel is a new general purpose cold work die and mold steel whose strength and toughness approach those of high-speed steels. DC53 steel, is an improvement over alloy tool steel D2 specified in Standard (JIS) G4404.
What are the features of Alro Steel dc53?
DC53also has excellent machining characteristics and is well suited as a substrate for PVD surface treatments. DC53can also be hot process CVD and TD (Thermal Diffusion) coated, however post heat treat is generally recommended. Chemical Composition %
What is the high temperature double draw dc53?
The high temperature double draw 520° C (970° F) or higher was part of the development criteria in determining alloy content, and heat treat requirements for DC53. This high temperature double temper relives a considerable amount of stress in the steel which in turn minimizes movement in the part when Wire EDM cutting hardened DC53.
Which is better DC2 or dc53 wire Edming?
Less residual stress after wire EDMing. DC53 can typically be machined 20% to 40% faster than D2 while experiencing as much as 50% less tool wear and breakdown. Faster feeds and speeds reduce machining cost and yielding an improved surface finish. DC53 was initially developed with the Wire EDM process in mind.
