How big is the shaft on a S10?
How big is the shaft on a S10?
According to S10 Planet, the 7.5-inch shaft has 26 splines, or grooves, while the 7.625 has 28 splines. A native of New Haven, Conn., Floyd Drake III began writing in 1984. His work has appeared in the “New Haven Register,” Medford’s “Mail-Tribune” and the “Ashland Daily Tidings.”
How to identify a GM S-10 rear end?
All three units have 10 bolts, as they are all variations of the GM Corporate 10-Bolt. Match the shape of the differential cover on the back of the rear end housing to the gasket shape chart found on Roadkill Customs Differential Identification page.
What’s the difference between S10 and 7.625 inch differentials?
Remove the differential input shaft to count the number of splines. The input shaft enters the unit from the transmission and must be removed, as the differences between the 7.5-inch and 7.625-inch differentials are internal. According to S10 Planet, the 7.5-inch shaft has 26 splines, or grooves, while the 7.625 has 28 splines.
What was the gear ratio on a 1984 Chevy truck?
A three-speed manual and four-speed manual with overdrive were also available, along with three-speed and four-speed automatic transmissions. The four-speed manual transmission had the widest gear ratio, ranging from 6.55:1 to 1.00:1.
What kind of car was the 1984 Chevy S10?
1984 Chevrolet S10 Pickup When talking about the 80s model Chevy S10 pickup the words fast and badass probably dont often come up. Well one cruise around the block in this custom is sure to forever…
According to S10 Planet, the 7.5-inch shaft has 26 splines, or grooves, while the 7.625 has 28 splines. A native of New Haven, Conn., Floyd Drake III began writing in 1984. His work has appeared in the “New Haven Register,” Medford’s “Mail-Tribune” and the “Ashland Daily Tidings.”
What was the rear differential on the Chevy S-10?
by Floyd Drake III. The Chevrolet S-10 pickup truck, one of the first compact models manufactured by a domestic auto maker, was equipped with three different rear-differentials, or rear ends. According to Chevy High Performance, the 7.5-inch was standard until 1993, when the previously optional 7.625-inch became standard.
Where is the rear end on a S-10?
Although these rear end units are similar in appearance, the 8.5-inch has visual differences, however, the 7.5 and 7.625 differences are internal and driveshaft splines must be counted. Look under the rear of the vehicle. The rear end is centrally located between the rear wheels.
