How do you replace the tail gate latch?
How do you replace the tail gate latch?
Once the latch cover is off, you will see the assembly. Two push rods are connected to the assembly just below the handle by small plastic clips (white and blue in this picture). Open the tail gate and little and hold it so it is just about to close. Rotate the clips down to detach them from the push rods, and then pull out the push rods.
How to replace a tailgate lock cylinder [ step by step ]?
Part 1 of 1: Replacing the tailgate lock cylinder Step 1: Remove the access panel.. Lower the tailgate and locate the access panel on the inside of the gate. The screws… Step 2: Locate and remove the old cylinder.. The lock cylinder will be held in a handle housing or retained with a clip… Step …
How do you replace the tailgate latch on a bedliner?
Use a T15 bit and remove all the bolts securing the liner to the tailgate. Step 2: Using a 13mm socket, remove the 3 bolts from the latch assembly. (if you have the bedliner, remove the two above the liner, remove the liner, than remove the third bolt.)
Where do you put the key for the tailgate?
If not, you will have to use a separate key for the tailgate. Step 1: Remove the access panel. Lower the tailgate and locate the access panel on the inside of the gate. The screws holding the access panel are around the tailgate handle area. Note: The exact size and number of screws will vary by make and model.
What to do if your tailgate lock is faulty?
If a power tailgate locking assembly is faulty, pressing the lock or unlock function will not change the lock position either. The tailgate locking assembly can be mechanically operated with a key, opened by pushing a button on the car’s inside, or accessed remotely by an incorporated electronic actuator.
How often does tailgate lock assembly replacement cost?
Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. How much does Tailgate Lock Assembly Replacement cost? It depends on the type of car you drive and the auto repair shop you go to. Our mechanics are mobile, which means they don’t have the overhead that repair shops have.
If not, you will have to use a separate key for the tailgate. Step 1: Remove the access panel. Lower the tailgate and locate the access panel on the inside of the gate. The screws holding the access panel are around the tailgate handle area. Note: The exact size and number of screws will vary by make and model.
What does a cylinder on a tailgate do?
Average rating from 130,525 customers who received a Tailgate Lock Cylinder Replacement. A tailgate lock cylinder is the actual device that accepts the proper key, and allows the cylinder to unlock the unit inside that is securing the tailgate handle.
