Can I use IC40 instead of IC20?
Can I use IC40 instead of IC20?
BestJoeyEver said: One note, the IC40 and IC20 use the same power center. So if you decide to upgrade later, you can. The IC60 uses a bigger power center so if you want to upgrade, there’s a bigger expense.
What should my Pentair salt cell be set at?
The IntelliChlor SCG is designed only to produce chlorine. The IntelliChlor SCG does not monitor or control chlorine levels in the pool or spa water. It is the pool ownerʼs responsibility for monitoring and maintaining free chlorine levels at the APSP recommended range of 2.0 to 4.0 parts per million (ppm).
Why is my IntelliChlor not producing chlorine?
A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.
How do I turn off IntelliChlor IC40?
Since you have the easy touch load center, go to the menu-settings-intellichlor then disable.
What is the difference between an IC20 and IC40?
Refers to the size of your pool IC20 is for a 20,000 gallon pool and an IC40 is for a 40,000 gallon pool. The IC40 does up to a 40,000 gallon pool.
How do I know if my Pentair salt cell is bad?
Signs of a Potential Problem
- The power center displays a Check Salt message.
- The Cell Warning light displays consistently, shutting off for only a short while after cleaning.
- Voltage is higher than normal.
- Amperage is irregular (it should normally be zero or just slightly above)
How long does a Pentair ic40 last?
Expect to get about 5 years of use out of your IntelliChlor chlorine generator — it obviously will depend on how much you use it and whether or not you maintain it properly, but, if all goes well, it should last you about five years. TIP: Consider buying the next model up and running it at a lower level.
How do you test an IntelliChlor salt cell?
Submerge the salt cell in a bucket of pool water, but do not get the wiring connections wet. Turn on the pump and activate the salt system. Put the output on the salt system at 100% for this test. Put the output back to the original setting when you are done.
How long does a Pentair IC40 last?
