How much oil does a 700R4 transmission hold?
How much oil does a 700R4 transmission hold?
| Transmission Fluid Capacity | |
|---|---|
| Transmission (w/ Stock Pan) | # of Quarts |
| GM 700R4/4L60E | 6 |
| GM 2004R | 6 |
| GM 4L80E | 7.7 |
Is the Process 208 a 4WD transfer case?
The NP219 was a full-time 4wd transfer case. This transfer case was more complex than the 208 in that it used a viscous clutch. The NP219 was used for two years in Jeeps and then replaced by the 228/229 in 1982. The NP228 had a direct-drive 2wd mode.
Is the NP208 transfer case part time or manual?
The NP208 was manufactured with manual shift, it is a replacement unit for the earlier units, it is a part time case, the front driveshaft will not receive power when in 2WD. The transfer case is, chain driven, 2.62:1 ratio reduction in low and 1:1 in high range, and a manual shift.
When did the New Process Gear NP208 come out?
The New Process Gear NP208 transfer case was an innovative aluminum, chain-driven transfer case used in a variety of vehicles from the big three American automakers. It was installed in 1980-1986 Ford pickup trucks, 1980-1987 Dodge pickups, 1981-1988 Chevy/GMC pickups and certain 1980-1990 Jeep models.
Do you need a rebuild kit for NP208?
Are you having problems with your NP208 transfer case and need a rebuild kit or replacement parts? The New Process NP208 transfer case is a strong, reliable unit that features 2.69:1 low range, chain driven aluminum case and is a lot lighter then other cast iron case of the time. The output drop for the front driveshaft is on the drivers side.
The NP219 was a full-time 4wd transfer case. This transfer case was more complex than the 208 in that it used a viscous clutch. The NP219 was used for two years in Jeeps and then replaced by the 228/229 in 1982. The NP228 had a direct-drive 2wd mode.
The NP208 was manufactured with manual shift, it is a replacement unit for the earlier units, it is a part time case, the front driveshaft will not receive power when in 2WD. The transfer case is, chain driven, 2.62:1 ratio reduction in low and 1:1 in high range, and a manual shift.
The New Process Gear NP208 transfer case was an innovative aluminum, chain-driven transfer case used in a variety of vehicles from the big three American automakers. It was installed in 1980-1986 Ford pickup trucks, 1980-1987 Dodge pickups, 1981-1988 Chevy/GMC pickups and certain 1980-1990 Jeep models.
Are you having problems with your NP208 transfer case and need a rebuild kit or replacement parts? The New Process NP208 transfer case is a strong, reliable unit that features 2.69:1 low range, chain driven aluminum case and is a lot lighter then other cast iron case of the time. The output drop for the front driveshaft is on the drivers side.
