How do you connect throttle cable?

How do you connect throttle cable?

Push the new cable through the firewall and into the engine compartment. Step 2: Hook the new cable up to the accelerator pedal. Slide the new cable through the slotted hole in the accelerator pedal. Step 3: Reconnect the throttle cable to the retaining bracket.

How do you change the throttle position on a Cavalier?

Use the torx screwdriver or socket to loosen the two bolts on the Cavalier’s throttle position sensor, then remove them by hand. Pull the throttle position sensor off; you may have to wiggle it back and forth to remove it. Place the new throttle position sensor in its place.

What do I need to replace TP sensor on Cavalier?

Replacing the TP sensor is simple, quick and inexpensive. It is recommended to use GM factory parts when replacing items on your Chevrolet Cavalier. Disconnect the negative battery cable for safety and gather the tools and parts needed for replacement. Locate the throttle position sensor.

How do you adjust the throttle valve cable?

Tip: Consult the owner’s manual for any specifications for your car’s make and model. Adjust the cable by a small increment then have your helper press the gas pedal all the way down and check the cable at WOT. Lengthening the cable will allow the vehicle to shift earlier and the shift will be softer.

How do you remove the throttle position sensor?

Pull the throttle position sensor off; you may have to wiggle it back and forth to remove it. Place the new throttle position sensor in its place. Tighten the torx screws and reconnect the electrical connection and the negative battery cable.

Where is the throttle cable in a car?

Position the application throttle control in the fast throttle position. Then move the throttle control back 3/16″ (4.75 mm). Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.

How do you put throttle control on a car?

Grasp the control cable and place it under the cable clamp. Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast.

How to fix a sticking accelerator cable throttle body?

– YouTube How To: Fix a Sticking Accelerator Cable Throttle Body, replace TPS Sensor & Adjust Throttle Cable. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

How to fix a stuck accelerator cable on a Nissan Quest?

Please try again later. This is a how to video showing step by step instructions on fixing your stuck or sticking accelerator cable on your Mercury Villager or Nissan Quest. It outlines the process of cleaning a dirty throttle body assembly, changing the tps throttle position sensor and setting the tension of the accelerator cable. Loading…