Where does the inner tie rod go?
Where does the inner tie rod go?
steering arm
The inner and outer tie rods connect to the steering arm in order to move the wheels of your vehicle. In the common rack-and-pinion steering system, the inner tie rods connect to the steering rack while the outer tie rods connect to the steering arms.
How do you replace the tie rod on a car?
Connect the tie rod end to the steering knuckle. The shaft of the tie rod end will fit down through the knuckle just as the old tie rod end did. You can move the knuckle and the tie rod end as needed to get them to align properly. Tighten the castle nut.
How do you remove tie rod from steering knuckle?
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.
How do you remove the tie rod from a cotter pin?
Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through. It holds the tie rod end to the steering knuckle. Removing it will allow you to remove the outer tie rod end. Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator.
How do you replace an outer tie rod?
Move the pinch nut up to touch the outer tie rod end. This will mark the location of your outer tie rod end and you will know how far to thread on the replacement. Do not tighten the pinch nut. If you do, you will not be able to easily turn the outer tie rod end. Remove the cotter pin.
Where are the tie rod ends on a car?
Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.
What happens if you have a tie rod malfunction?
Once they start to malfunction, your car may not control the way it should anymore. If your tie rods have been malfunctioning for a while, they can cause additional stress on many other parts of the steering system. Over time, that creates damages that can be expensive to repair.
