Easy tips

What should I check on my 700R4 no reverse?

What should I check on my 700R4 no reverse?

Well off to tear off the pan and check the oil filter, pressure regulator/tv boost/reverse boost valve and spring. By the way this has an upgraded .50 boost valve and pressure regulator spring. Hopefully that will take care of everything.

Is it possible to shift out of first gear on a 700R4?

On the drivers side of the trans is a rounded cover. Pry it off, it is just pressed on, and pull out the governor. It is common for the nylon gear at the end to get stripped, when this happens you will not be able to shift out of first gear.

What kind of warranty does a 700R4 have?

I am having trouble with a 700r4 that has about 40k miles on it. The transmission was a total rebuild from Jasper and they said they replace all parts not just the part that went bad. Warranty is 3yr/30k.

Can a TH-350 be converted to a 700R4?

So mine was a TH-350 to 700R4 conversion. 700R4 was a fresh rebuild that was purchased. Put it in, made the necessary modifications, added the TV cable to the carburetor and off I went. To install the TV cable I held the throttle wide open and pulled all the slack and movement out of the cable, then locked in the set screw.

On the drivers side of the trans is a rounded cover. Pry it off, it is just pressed on, and pull out the governor. It is common for the nylon gear at the end to get stripped, when this happens you will not be able to shift out of first gear.

Well off to tear off the pan and check the oil filter, pressure regulator/tv boost/reverse boost valve and spring. By the way this has an upgraded .50 boost valve and pressure regulator spring. Hopefully that will take care of everything.

I am having trouble with a 700r4 that has about 40k miles on it. The transmission was a total rebuild from Jasper and they said they replace all parts not just the part that went bad. Warranty is 3yr/30k.

So mine was a TH-350 to 700R4 conversion. 700R4 was a fresh rebuild that was purchased. Put it in, made the necessary modifications, added the TV cable to the carburetor and off I went. To install the TV cable I held the throttle wide open and pulled all the slack and movement out of the cable, then locked in the set screw.

Where is the pressure Reg on a 700R4?

There are some ideas. You can get to the pressure reg and boost vavle in the pump with the pan off. Its the valve in the pump on the drivers side, little larger that a nickle. Did you put the sun gear in the reaction drive shell? If you have fourth, it is in there.

What kind of washer does a 700R4 have?

But, you put the black thrust washer with the four round locater stubs on top of the shell, where the four tang bronze thrust washer goes. The plastic washer goes on the center support side of the shell. It has a 68 thrust washer on the input drum. I usually end up with a 69 or a 70.

Why is the reverse gear not working on my 4L60E?

Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage. Booster Valve- A bad booster valve can leave you without reverse in a hurry. Sun Shell- A broken sun shell will cause…

Author Image
Ruth Doyle