How do you change an ExerSaucer to an activity table?
How do you change an ExerSaucer to an activity table?
Take off the lower legs by unsnapping them from the ExerSaucer base. Turn the tray face down and unsnap it in half. Twist the ends of the tray to form an “S” shape. Reattach the legs by turning them counterclockwise until locked into place.
Where do the springs go on an ExerSaucer?
Rotate the spring dome as you press it downward into place until it locks. Align the lines around each opening with the notches on the spring domes. Lay the tray and seat upside down and insert the three springs onto the underneath of the spring domes. Put an upper leg piece over each spring and twist it into place.
How do I change the battery in my Evenflo ExerSaucer?
Battery Replacement: To replace batteries, loosen screw and remove battery door. Discard old batteries properly and replace with 3 AAA alkaline batteries. Replace door and tighten screw.
What does ExerSaucer mean?
An exersaucer is a stationary play center for your baby that has a round base and an elevated seat for them to sit. They are conceptually similar to a walker but your baby’s feet do not touch the ground. The main role of an exersaucer is to let your baby remain upright while playing or during the day in general.
Where do the springs go on an exersaucer?
How do you put a seat on an Evenflo ExerSaucer?
Turn the seat base right side up. Line up the triangle on the back of the base with the triangle on the back of the seat pad label. Keep the triangles aligned and snap each tag on the inside of the seat pad into the tabs on the base. Insert the seat into the ExerSaucer’s tray and press down firmly until you hear it snap into place.
When do you stop using the Evenflo ExerSaucer?
Snap each toy or activity piece into place on the tray. Toys and activities vary by ExerSaucer model. Evenflo recommends stopping use of ExerSaucers when your baby begins walking; reaches 30 inches tall; stands flat-footed when the seat is at its highest position; or when your child can climb out of the product.
How do you install an ExerSaucer on a base?
Install the 1- and 1/2-inch spring screws onto the pedestals. Push the pedestals through the pedestal holes on the upturned base, making sure the locking tabs are completely pushed through to keep the pedestals from popping off. Clip the ExerSaucer legs onto the pedestals of the base, making sure each clicks into place.
