How to read and clear a Chrysler airbag code?

Chrysler airbag codes can only be read and system cleared with an airbag specific scan tool such as Maxdiag, Autel, OTC. Chrysler vehicles with Occupant Classification System (OCS) codes require vehicle specific equipment and procedures to reset.

What does the code on the air bag indicator mean?

If the system detects any problems, it gives you a signal through the airbag indicator by flashing the light several times, giving you the specific problem the test has detected. These flashes are codes, each having its own meaning. The supplemental restraint system (SRS) warning light is most commonly known as the airbag system light.

Do you need scanner to read airbag trouble codes?

Working with your airbag system is crucial, and therefore, always read the trouble codes with an OBD2 scanner to get an idea of where to start your troubleshooting. Do never clear the trouble codes before you fix the problem caused by the airbag light.

Is the SRS warning light an air bag code?

These flashes are codes, each having its own meaning. The supplemental restraint system (SRS) warning light is most commonly known as the airbag system light. This is a computer controlled system designed to deploy one or more driver, passenger, and side airbags. How to read air bag codes ?

Do you clear trouble codes before resetting airbag light?

Do never clear the trouble codes before you fix the problem caused by the airbag light. Read the codes and get information about what can cause the problem and therefore continue the diagnosis. You should never just reset the airbag light without repairing the problem.

What are the airbag codes on a Chevy Chevorlet?

Call us at 888-779-9029 M-F 9-5 EST Review the GM Chevorlet airbag codes list below: RF/Passenger Frontal Deployment Loop (Stage 2) Resistance Low Passenger Airbag Module Deployment Circuit -Ckt Resistance Low (Stage 2)

Can a Chevy airbag be reset by myairbags?

The best part of having your Chevy’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required to fix your airbag codes.

What does the my airbag reset code mean?

MyAirbags will reset your airbag control module back to its original manufacturer state clear of all codes, both soft and hard codes. Typically, these codes will indicate that there is crash data stored, airbags deployed, communication failure, a full memory, or other airbag, seat belt related issues.

What is the diagnostic code for an air bag?

Codes 41 to 45 pertain to problems with the RH and LF primary crash sensor. Airbag diagnostic codes go up to 53. It is important that you familiarize yourself with these codes so you get the appropriate airbag repair services. After running the diagnostic, the air bag light needs to be reset.

What does the code 13 on an air bag mean?

Code 13 (single flash, pause, three flashes) means that the airbag circuit has shorted to ground and Code 14 (single flash, pause, four flashes) means that the primary crash sensor circuit has shorted to ground. These codes are signaled by two flashes, a two-second pause and the number of flashes that corresponds to the second digit.

How to clear the airbag fault code chart?

Each code is two digits and is counted by quick flashes and pauses. So a flash, flash, pause, flash equates to a code 21 on the fault code chart. Clear the codes with a jumper wire or by a specific brand scanner.

What does the code 21 mean on a Ford airbag?

Codes 21 to 24 These codes are signaled by two flashes, a two-second pause and the number of flashes that corresponds to the second digit. Code 21 (double flash, pause, one flash) means the diagnostic monitor is not mounted properly.

How to read and clear a Chrysler airbag code?