How to replace the rear disc brakes on an uplander?
How to replace the rear disc brakes on an uplander?
Reinsert the outer bearing cone, washer and nut. Push the cotter pin back into its proper place and cover it with the grease cap. Reinstall any shims you may have removed. Spray brake quiet lubricant onto the backside of the brake pads then install the brake pads onto the caliper.
How are rear disc brake pads fitted on a car?
A locator slot is used on the inboard piston, which is fitted into a peg located on the backing plate of the pad. Rear disc brake pads offer improved performance and are not affected by moisture like conventional brake shoes.
Is there a reset tool for rear brake pads?
Brake pad design configuration may vary slightly, but the concept is the same. A rear caliper reset tool is necessary for parking brake integrated systems. The reset tool screws the piston back into the caliper. These calipers cannot be compressed with a clamping tool, it can only be reset with the reset tool.
How do you reset a rear brake caliper?
A rear caliper reset tool is necessary for parking brake integrated systems. The reset tool screws the piston back into the caliper. These calipers cannot be compressed with a clamping tool, it can only be reset with the reset tool. A locator slot is used on the inboard piston, which is fitted into a peg located on the backing plate of the pad.
What kind of brake fluid do you use on a Chevy Uplander?
Remove the cap to the master cylinder and fill the reservoir with DOT 3 brake fluid until the level of the fluid is within 1/4 inch of the top of the container. Replace the master cylinder cap. DOT 3 brake fluid is the recommended fluid for the Chevy Uplander.
Where do you put the Jack on an uplander?
Park the Uplander in an area that will allow for access on both sides of the vehicle. Place the transmission in “Park,” point the front tires forward and place tire blocks behind the rear tires. Loosen the lug nuts on the front wheels with the socket on the tire iron. Place the jack beneath the frame near the front bumper and lift the vehicle.
Reinsert the outer bearing cone, washer and nut. Push the cotter pin back into its proper place and cover it with the grease cap. Reinstall any shims you may have removed. Spray brake quiet lubricant onto the backside of the brake pads then install the brake pads onto the caliper.
Remove the cap to the master cylinder and fill the reservoir with DOT 3 brake fluid until the level of the fluid is within 1/4 inch of the top of the container. Replace the master cylinder cap. DOT 3 brake fluid is the recommended fluid for the Chevy Uplander.
Park the Uplander in an area that will allow for access on both sides of the vehicle. Place the transmission in “Park,” point the front tires forward and place tire blocks behind the rear tires. Loosen the lug nuts on the front wheels with the socket on the tire iron. Place the jack beneath the frame near the front bumper and lift the vehicle.
