What is the diagnostic code for transfer case?
What is the diagnostic code for transfer case?
Diagnostic Trouble Code C0306 is set once the Transfer Case Control Module detects an open, short-to-ground, or low voltage in the Motor Control A or B circuit, or an open or short-to-ground fault inside of the transfer case motor.
How does a two wheel drive transfer case work?
The transfer case motor rotates the actuator shaft which moves the transfer case two/four wheel drive actuator cam and transfer case high/low shift fork to shift the transfer case between the following modes or ranges: 2 HI, 4WD HI, 4WD LOW, Neutral
Where is the encoder motor on a GM transfer case?
Access to datastream information for GM’s NVG 246 system makes most problems simple to locate and diagnose, as our case studies demonstrate. These systems also allow bidirectional control for many outputs. The encoder motor (arrow) is mounted on the front of the transfer case and is used to lock it into 4WD.
What is the 4 wheel drive trouble code?
In addition to the Service 4 Wheel Drive Message, you may also have a C0387 or a C0569 trouble code stored. 2007–2009 Chevrolet Avalanche, Silverado, Silverado Hybrid, Suburban, Tahoe, Tahoe Hybrid
How does the transfer case motor lock work?
1. The transfer case motor lock feature detects the improper voltage. 2. The Transfer Case Control Module (TCCM) detects no voltage going to the Transfer Case Motor (TCM) lock feature. How to access the diagnostic trouble code (DTC):
Where is the shift relay code on a Ford F-250?
Pull the codes and see if you have a shift relay code. But check your fuses and the shift relays under the hood.
What to do if your F-250 Super Duty wont start?
Lift the block the relays are plugged into, look for greenish white powder around the drain hole. If none then open and inspect the inside, beneath the relays. Look for any signs of corrosion. Your problem is prob there.
Is the transfer case on the F-150 the same as the F 250?
Both the Ford F-150 and F-250’s engines have similar transfer case setups even though their transmissions are different. The process for removal and installation is the same, however. Always remove the battery terminals before starting any work.
Where is the transfer case on a Ford Focus?
The transfer case on your Ford is a heavy piece of equipment your transmission uses to send power to the front and rear wheels. It is located behind the transmission and is not too difficult to remove, but care must be taken to avoid injury when removing this heavy piece of equipment.
Where is the drain plug on a F-150 transfer case?
Use a 3/8″ ratchet to loosen the drain plug. The drain plug is located on the bottom left. The top plug is used for filling. Remove the top plug and then remove the bottom. This will help to drain faster. Figure 3. Drain the fluid before removing the transfer case. Unbolt the rear drive shaft from the transfer case.
How do you replace a truck transfer case?
The transfer case is heavy. After removing the bolts set it on an extra floor jack if you have one and wheel it out. Set the new transfer case and wheel it back under and jack it back up into place. Use a metal cleaner to clean the mating surfaces between the truck and the new transfer case.
