What does f1 code mean on motorcycle?
What does f1 code mean on motorcycle?
The FI means there is a fault and you need to put the bike in dealer mode to pull the code. The code will tell you what is wrong. Do not ride the bike till you get the issue resolved.
How do you clear FI code on GSXR?
Fi codes can be reset by jumping the pins on the white service plug under the pillion seat. It is a white plug with grey foam on it, under pillion seat on right hand side (If you are sitting on it). Turn on ignition and then off, then on again.
Where is the tip over sensor GSXR?
The sensor is located in the tail and it is a small black box…about 1″X.
How do I put my bike in dealer mode?
Registered
- You will need to make your ‘dealer mode tool’…
- Locate the Dealer Mode Activation Connector.
- Turn off your ignition and put your ‘dealer mode tool’ in the two terminals that are next to each other.
- With the ‘tool’ still in the connector turn on your ignition.
What is the FI light on a Suzuki?
Whenever the red indicator light is lit and the display indicates “FI” have your authorized Suzuki dealer or qualified mechanic inspect the fuel injection system as soon as possible.
What does it mean when the f1 light comes on?
It stands for Fuel Injection and is a secondary warning that the detected fault is with the Fuel Injection system.
How do I put my 2007 GSXR in dealer mode?
When you go to put it in dealer mode, it must show FI on the dash and you must put it in dealer mode without turning off the ignition at key and/or kill switch or you erase the code(s). Then you have to wait till FI pops up again, take it to a dealer or buy the SDS tool to pull the stored codes.
What does FI mean on a four wheeler?
Opt for Fuel Injection When Buying a Honda ATV At the time, a computer-based fuel mixing system was an innovative feature. Other models were still using an airflow meter. Since then, the system has evolved into Honda’s well-known Programmed Fuel Injection (PGM-FI) component.
Where do I get the F1 code on my Suzuki GSXR?
The switch is the way to go because this is a pain to do everytime you have a code. There is a plug in the tail section, you can buy “dealer switch” and connect to it, if ever “F1” code shows, you simply click the switch, and get the code on your dash…
Where is the dealer mode switch on a Suzuki GSXR?
Location of dealer mode switch and how to get the codes. The dealer mode connector is under the tail cowling on the left side of the bike, near the regulator/rectifier. It will have only two wires going to it. It is is small white connector that does not plug into anything, and has a rubber cap on one end. Click to expand…
When does CHEC show up on Suzuki GSXR?
First off, “CHEC” will show up when the instrument cluster has not received data from the ECM for a few seconds, it does not mean you have any fault. When the kill switch is not in the run position, there is no power to the ECM, hence no data to the cluster, so CHEC pops up. This is normal.
When do I get a code C24 on my GSXR?
In this case, the code c24 or C25 or C26 or c27 is indicated. When no actuator control signal is supplied from the ECM or communication signal does not reach ECM or operation voltage does not reach STVA motor, C28 is indicated. STVA can not operate. STVA, lead wire / coupler connection.
