How do you bleed ABS module with scan tool Silverado?

How do you bleed ABS module with scan tool Silverado?

Scan Tool

1. Attach a pressure bleeder to the master cylinder reservoir and turn the ignition key to the On position.
2. Connect the scan tool and set it to “Automatic Bleed Procedure.” Wait one minute for the tool to energize and cycle the ABS solenoids.
3. Bleed each wheel as the scan tool instructs you to.

How do you bleed ABS pump with scan tool?

Select the Automatic Bleed Procedure on the scan tool. The scan tool will then energize and cycle the ABS solenoids in the BPMV for one minute. After this, the scan tool will instruct you to bleed each wheel. During this step, the pump runs and the respective release valve cycles for one minute.

How do you Bleed ABS on a Chevy Silverado?

3.With bleeder screws closed, pressurize the system to 35 psi. 4.Select the “Automatic Bleed Procedure” on the scan tool. The scan tool will then energize and cycle the ABS solenoids in the BPMV for one minute. After this, the scan tool will instruct you to bleed each wheel.

How to check Brake bleeding with scan tool?

11.When the desired pedal height is achieved, press the brake pedal in order to inspect for firmness. 12.Remove the scan tool. 13.Install the tire and wheel assemblies. 14.Inspect the brake fluid level. 15.Road test the vehicle while inspecting that the pedal remains high and firm.

Which is the best GM scanner for ABS bleeding?

Vident iLink400 GM scanner is also able to do ABS bleeding. Read Vident iLink400 GM function list: http://www.uobdii.com/upload/pro/19102615720743541414.zip There are 2 tables, one is ” funtion list” and another one is ” special function”, search “ABS” in the table of ” special function”.

Is it possible to bleed brakes on a Chevy Silverado?

Not true for humans, but sometimes true for hydraulic braking systems. This article applies to the Chevrolet Silverado GMT900 (2007-2013). Bleeding brakes is a war against the most devilish villain in a hydraulic system: air.

3.With bleeder screws closed, pressurize the system to 35 psi. 4.Select the “Automatic Bleed Procedure” on the scan tool. The scan tool will then energize and cycle the ABS solenoids in the BPMV for one minute. After this, the scan tool will instruct you to bleed each wheel.

How to bleed ABS brakes without scan tools?

The Procedure of How to Bleed ABS Brakes. 1 Loosen the Bleeder Valves. After preparing the vehicle, your first task is to loosen the bolts of the bleeder valves. Use a box wrench for the job. If 2 Remove the Old Fluid. 3 Bleed the ABS System. 4 Bleeding with a Scan Tool.

Can You Bleed the brake lines on a Chevy Silverado?

If this is not done, you won’t be able to bleed the rear brake lines. With the Tech 1 or similar scan tool, select the F4 ABS Test mode, then select the F0 “manual control” option.

Do you need a SnapOn scanner for a GM Truck?

You don’t need a tech 2 (the old GM scan tool) or a snapon scanner. All you need is a scan tool capable of bidirection communication. Which means it can not only read the vehicle but can also send commands to it. Most of the cheap code readers are just that, a tool to read codes and other info.