What to do if your GM pick up has no start?

One of the most overlooked areas, when testing a hard to diagnose no-start, is the mechanical condition of your 4.3L, 5.0L, 5.7L GM pick up, van or SUV. Checking the engine mechanical condition means an engine compression test.

When was the first Chevy pickup truck made?

Among these was the first compact pickup truck to be built in the U.S. by a “Big Three” automaker, the Chevrolet S-10, which was released in 1982.

Why does my Chevy truck not shift out of first gear?

One possible cause of this issue could be the ignition control module or ignitor. Once they age, they are very susceptible to heat and temperature. Another possibility could be a main relay as well. Fault codes should be read…

When did the Chevy el 4 wheel drive come out?

1992: Chevrolet introduced a four-wheel-drive entry-level model, dubbed the EL. All four-wheel-drive models except the EL had the option of a new electronic shift transfer case. 1993: Automatic S-10s received a new heavy-duty cooling system, which included an engine oil cooler and a transmission oil cooler.

What kind of truck is a 2001 Chevy Silverado?

It’s a 8 cylinder Onyx Black truck that can get the job done. Description: Used 2001 Chevrolet Silverado 1500 LT with Towing Hitch, AWD/4WD, Rear Bench Seats, 8000lb Towing Capacity, Heated seats.

How to test shift solenoids on GM 4.3L?

In this article, I’ll show you how to test the transmission shift solenoids (specifically 1-2 solenoid and 2-3 solenoid) on your GM 4.3L, 5.0L, 5.7L pick up, van, SUV. You’ll be surprised just how easy it is to diagnose these shift solenoids when they have failed.

Are there any Chevy 4.3 V6 engines left?

Only 4 left in stock – order soon. . Only 1 left in stock – order soon. . Only 2 left in stock – order soon. . Only 4 left in stock – order soon.

What kind of car is 2001 Chevy S10?

Consumer Ratings Rank Vehicles HP #2 2003 Ford F150 Regular Cab 231 #3 2001 Dodge Ram 1500 Regular Cab 230 #4 2004 Ford F150 (Heritage) Regular Cab 202 #5 2001 Chevrolet S10 Regular Cab 180

Why does my car not start when I turn the key?

This condition is usually due a failed fuel pump, a failed ignition coil, a failed ignition control module, a failed crank sensor, etc… that lets the engine crank (turn over) but does not let it start. A No Crank Condition means that the engine is not turning over when you turn the key to crank the engine.

What causes a Chevy C / K to stop running?

A leaky fuel pump will drain the line up to the carb, but about 15 seconds of cranking will fill the line again. 2. A sticking mechanical choke or a bad electric choke. Try; when you return to your truck from the Quicky Mart, put the accelerator slowly all the way to the floor, let your foot up slowly and then crank the engine.

What does it mean when your car says no start?

A No Crank Condition means that the engine is not turning over when you turn the key to crank the engine. The most common problem, that causes this condition is a failed starter motor. If your vehicle is suffering a No Crank Condition, this tutorial may be a good starting point: How To Test The Starter Motor (GM 4.3L, 5.0L, 5.7L).

When does the Chevy Silverado 1500 shut down?

See all problems of the 2009 Chevrolet Silverado 1500 . While slowing down to make a turn, usually always using turn signal, my truck will completely shut down in the middle of the intersection with no warning. The engine shuts down and all electrical is lost.

Why is my Chevy Silverado 1500 not starting?

However, today, when the truck will crank and start, the antitheft icon goes off after a few seconds with the key on and stays off while the truck is running. It never flashed either today or yesterday though. And I don’t know if the antitheft system disables cranking or starting or both.

Why does my Chevy Silverado want to turn over?

Truck wants to turn over but will act as if is starving for fuel,wait ten minutes, it start. Been happening frequently lately. I also was told it was the security system Will turn key and it is like no power from battery to starter, but have lights, radio, etc. Turn key again or sometimes multiple times, to no avail.

Can a Chevy Silverado 1500 lose all power?

See all problems of the 2019 Chevrolet Silverado 1500 . Truck will lose all power, everything will shut off, and then come right back on. It has happened while accelerating into traffic, slowing down turning right and turning left, and while moving straight ahead.

What should compression reading be on GM 4.3L?

When performing an engine compression test, what you’re looking for is an average compression reading of less than 90 PSI across all or the majority of the engine cylinders. If you have one or just two readings that are under 90 PSI your GM vehicle will still start and run, albeit with a misfire condition.

What do I need to troubleshoot GM 4.3L?

Here are some of the basic tools you’ll need: Fuel pressure gauge. Spark tester. Compression gauge. Multimeter. You can find a complete list of tutorials here: GM 4.3L, 5.0L, 5.7 Index Of Articles. Below, is a sample of articles you’ll find in this index of articles:

How to read a GM check engine light code?

It will look like Morse Code, but it isn’t, and is real easy to interpret. The first code that will flash will be a code 12. It will be “flash, pause, flash, flash, pause, pause,” and repeat the cycle three times. The ECMwill flash each code three times, and move on to the next. If you have no codes stored, it will keep flashing code 12.

Where can I find the GM diagnostic trouble code?

Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other GM diagnostic trouble codes. Manufacturer Specific Codes P1031HO2S Heater Current Monitor Control Circuit Sensors 1

Are there any problems with the GM gauge clusters?

The next most common problem seen on GM instrument clusters are failing digital displays. This problem is unrelated to the stepper motor problem but is often seen in the same clusters. Most GM gauge clusters of this time frame have two digital displays – the odometer and the gear indicator (commonly called the PRNDL screen).

How to get a GM check engine light code?

GM Trouble Codes – Check Engine Light Codes 1 Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2 Turn the ignition on. 3 Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).

Can you replace an instrument cluster in a GM Silverado?

GM will replace instrument clusters with used instrument clusters that have been rebuilt when a replacement is required. They then send your old instrument cluster to their 3rd party repair partner to be rebuilt and sold to the next customer needing it.

How often does my GMC Truck turn over?

So far this has been the case pretty much every time i am starting the truck cold. I’ll try to start it and it will turn over for about 3-4 seconds (have tried a bit longer, still no go) then i’ll stop and try to start it again, and the second time it fires right up.

Why does my GM car say no start no crank?

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

Why does my GMC Sierra 1500 not start?

Happened before, I gave it air, it started, thought bad filters, then noticed no umph in acceleration, leads me fuel line or bad plugs, not burning fuel. Checked carb, It’s not wet this time, leads me to fuel.

What to do if your GM pick up has no start?