Easy tips

How to reset change engine oil light on Chevy Silverado?

How to reset change engine oil light on Chevy Silverado?

Today we will talk about how to reset the oil change light on the Chevy Silverado. The new Silverado has an oil life system set up based upon how you drive, so how hard you drive, how hard you hit the gas, whether you’re doing a ton of highway miles or a ton of cine biles changes how soon you need to change the oil on this vehicle.

How to reset Chevy Silverado 1500 Classic LS?

Chevrolet Silverado 1500 Classic LS: To reset the oil change…. Fully push and release the accelerator pedal 3 times within 5 seconds. If the “Change Oil Soon” light flashes, the system is resetting. Start the vehicle. The oil life will change to 100%. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.

When to add oil to a Chevy Silverado?

Check the oil level as soon as possible. Add oil if required, but if the oil level is within the operating range and the oil pressure is still low, have the vehicle serviced. The Oil Life display must be reset after each oil change.

How do I reset the oil soon light?

Turn the ignition key to the RUN position. Fully push and release the accelerator pedal 3 times within 5 seconds. If the “Change Oil Soon” light flashes, the system is resetting. Start the vehicle. The oil life will change to 100%. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.

How to reset the oil soon light on a Chevy Silverado?

Chevy Silverado Truck Change Engine Oil Soon Light Reset Steps: 2011-2015 Display the “Oil Life Remaining” message in the Driver Information Center Press and hold the SET/RESET button on the Driver Information Center for more than 5 seconds (on vehicles without DIC, use the TRIP reset stem for SET/RESET)

Chevrolet Silverado 1500 Classic LS: To reset the oil change…. Fully push and release the accelerator pedal 3 times within 5 seconds. If the “Change Oil Soon” light flashes, the system is resetting. Start the vehicle. The oil life will change to 100%. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.

How do you change the oil in a Chevy?

For second generation models (2007-2013): Step 1: Insert key into the ignition and turn the vehicle to the “ON” position. Do this without starting the vehicle. Step 2: Press the accelerator pedal to the floor three times within five seconds. The “CHANGE OIL SOON” light should begin to flash, which means the system is resetting.

What kind of oil does a Chevy Silverado use?

If your Silverado 1500 is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Silverado 1500. Most Chevrolets have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.

Author Image
Ruth Doyle