What does Code F mean on Kenmore washer?
What does Code F mean on Kenmore washer?
control detected a component problem
The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.
How do I reset my Whirlpool Duet washer F01?
You can try and reset the error by killing power to the washer at the breaker for one minute or unplugging the washer for one minute. Restore power and if the error persists you will need to replace the main control board.
What does the code ie mean on a Kenmore washer?
problem with water fill
The IE code indicates that the washer detects a problem with water fill. Make sure that the hot and cold water supply faucets behind the washer are fully open. You can shut off the water supply faucets and check the inlet water screens on the back of the washer for debris or deposits.
How do I fix F5 on my Kenmore washer?
It goes through the wash cycle and then ends with an F5 error and recurring beeping alarm. The “lid locked” LED flashes as well. The only way to clear the codes is to unplug and let sit, and then plug back in.
How do I fix F01 on my Whirlpool washer?
The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes. Be sure to unplug the washer before accessing internal components.
What does fo1 mean on washing machine?
Electronic circuit board fault
F01 — Electronic circuit board fault. Issue: Washing Machines is not operating – some or all functions are not selectable. Advice: We recommend you disconnect (unplug) the appliance from the mains supply for a minimum of 2 minutes. Reconnect supply and wait 30 seconds and try starting the machine again.
How do I fix Internet Explorer error on my Kenmore washer?
ERROR CODE IE Inlet water supply error Check the water supply faucets behind the washer to make sure they are fully open. Check the fill hoses for kinks or freezing (in winter). Check the inlet water valves. If the valves are defective, replace the inlet water valve assembly.
What causes an F28 code on a Kenmore washer?
A bad door lock/switch also prevents the motor control board from getting power, resulting in the F28 code. Replace the door lock/switch assembly if damaged. The cabinet has grounding switches on the front and back. Defective grounding switches can trigger the F28 code.
What to do if your Kenmore washer is not working?
Unplug the washer and check the wire harness connections between the motor control board and the main electronic control board. Reconnect any loose wires or replace the wire harness if damaged. If the wire connections are okay, replace the motor control board. Make sure the water supply faucets behind the washer are fully open.
What to do if your Whirlpool duet washer is not working?
Unplug the washer for 5 minutes, restore power and see if the code clears. If not, the replace the main electronic control board. Unplug the washer and check the wire harness connections between the motor control board and the main electronic control board.
