How to get rear brake drums to come off?
How to get rear brake drums to come off?
If they are not totally froze up…adjust the brakes DOWN (or in) so they are not so tight. TAP all around the drum, (not hard) with something hard, large screwdriver handle, wood, something to help loosen the built up dust.
Where are the holes in the rear brake shoe?
To use in the two threaded holes 180° from each other on rear drum used for drum removal. The holes are not to hold the drum at all or there would be bolts in the holes!
How is a brake drum puller attached to a wheel?
Place each of the brake drum puller’s 3 hooks evenly around the brake drum’s flange. Ensure that the screw in the middle of the brake drum puller lies above the middle of the wheel hub. Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum.
What should I do about my Pontiac Vibe brake drum?
My husband has a 2005 Pontiac Vibe. He took the Brake Drum off and at some point had our nephew step on the brake. Well after doing that he figured out that the brake drum will no longer go on and we can not find anything that states what to do. We have tried moving the Adjuster, but to no avail. Please help! helpful?
What’s the best way to remove a brake drum?
Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum. Do not over-tighten the screw on the brake drum puller. Knock the back of the brake drum lightly with a hammer. Tap the hammer against the brake drum with an outward motion.
What happens when you change the drum on a car?
Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.
Place each of the brake drum puller’s 3 hooks evenly around the brake drum’s flange. Ensure that the screw in the middle of the brake drum puller lies above the middle of the wheel hub. Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum.
Where is the adjuster screw on a brake drum?
Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum. Turn the adjuster screw counterclockwise until it comes to a halt.
