Can you replace the ignition switch on a GM car?

However if you came here to replace your ignition switch on your GM vehicle, watch the video below as well as the pictures on how to remove the dash components to access the switch mechanism. This ignition switch replacement applies to the following vehicles as they use the same switch part number.

How do you remove a battery from an ignition switch?

Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.

How to replace a no start ignition switch?

GM Ignition switch replacement to fix a no start or intermittent start. Faulty ignition switch contacts can also cause the PassLock system to enable Click here to see step by step proceedures. http://www.thejunkmanadv.com/the-junk… Support the site, buy service manuals here : http://www.tkqlhce.com/click-7357719-… Loading…

What to do if your key is stuck in the ignition switch?

The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.

Is there an easy fix for a GMC ignition switch?

This is one way to fix a very complicated electrical system in the Chevrolet and GMC cars and trucks. Some are easy fixes with loose or bad electrical connections. Others involve the ignition switch itself, and others involve one of the computers that the system communicates with when starting the vehicle.

Do you need a new ignition switch for a Sierra 1500?

If someone attempted to break into your car or the crevices in the switch are jammed, you need a new ignition switch for GMC Sierra 1500. Speak to an AutoZone professional about switches that are moisture and rust resistant and operate systems, such as the radio, even when the engine is off.

How do you replace the ignition switch on a Silverado?

Start by inserting the two additional connectors in the harness connector (the one with the screw in the middle). Then, plug the connector in under the steering column and tighten the screw. Plug in the connector in the back of the fuze box to the left, and the small connector in the middle of the harness.

Can you replace the ignition switch on a GM car?