How do you open rear wheel drum?

How do you open rear wheel drum?

Unscrew the brake drum if needed.

1. Use a screwdriver to remove the screws securing the brake drum to the wheel.
2. Draw the brake drum forcefully towards you.
3. Use a screwdriver and rubber mallet or a brake drum puller to take the drum off of the wheel if you are unable to remove the drum by unscrewing it and pulling it.

How do you remove the drum from a car?

Grab the brake drum by the edges and pull it off. It may help to wiggle it a bit as you pull. It may be necessary to back off the brake adjuster to remove the drum. This is done through the brake adjustment hole in the drum or on the backing plate using a brake adjuster tool to turn the adjuster to loosen the brakes enough to remove the drum.

How do you remove rear drum brakes on a truck?

Remove the brake line, then stick a bolt in the end of the rubber brake line to keep fluid from draining out. Remove the brake rotor (just pull it off). In the event that the truck has rear drum brakes, simply pull the drum off. Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket.

Where is the drum on a front wheel drive car?

The drum is held onto the axle, a stub axle in the case of a front wheel drive car, by a bearing and a single large nut.

Can a out of round drum cause rear wheel lockup?

Brake drum condition should be factored in when determining the cause of rear wheel lockup. An out of round brake drum or drums that vary in diameter too much from side to side could cause a one wheel lockup condition (Figure 61.8). Measuring drum runout or out of roundness is not easy in the field.

How to remove a brake drum that is stuck on?

Watch how to remove a brake drum that is stuck on. I go through the steps so anyone can remove their drum brake. In this case the drum adjuster was stuck so first try to get it off by wiggling back and forth. Then spray penetrating oil to remove rust between the drum and the seat. Then hit it with a hammer hard.

What happens when you change the drum on a car?

Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.

How is a brake drum puller attached to a wheel?

Place each of the brake drum puller’s 3 hooks evenly around the brake drum’s flange. Ensure that the screw in the middle of the brake drum puller lies above the middle of the wheel hub. Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum.