How to reset timing belt light on isuzu 4jg2?
How to reset timing belt light on isuzu 4jg2?
The reset is done by taking the clocks out of the dashboard. On the back there is a small silver screw, towards the middle. About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole.
How do you reset the timing belt light on a Toyota Fortuner?
You can do it as follows:
- Make sure the meter is set to ODO.
- Turn off the ignition.
- Press and hold the trip reset button and turn on the ignition whilst holding the button.
- Hold the button for about 5 to 10 seconds and release.
- The number 15 will appear on the display.
- Now press the button briefly.
How do you reset Isuzu 4JG2 timing belt light?
How does the timing belt reset button work?
So, the black box must have a cog attached to the worm drive (can’t see it) and the box counts six increments of the 10,000 mile digit and then triggers the light. The reset button tells it to stop counting and start again. The odometer just carries on incrementing. Is that how it works or am I barking up the wrong tree ?? Curious now . Bob.
How does the reset button work on a Land Cruiser?
The worm drive passes over a small black box that has electrical connections to the reset button. So, the black box must have a cog attached to the worm drive (can’t see it) and the box counts six increments of the 10,000 mile digit and then triggers the light. The reset button tells it to stop counting and start again.
Why does my timing belt warning light come on?
My warning light came on today at just over 120,000 miles. I had the timing belt changed at 106k so I was a bit concerned. The AA told me that the warning is linked to the odometer, rather than a sensor and that I don’t need to worry.
The reset is done by taking the clocks out of the dashboard. On the back there is a small silver screw, towards the middle. About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole.
How do you turn off timing belt light?
About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole. That switches the light off, you leave it there then until you need to change the timing belt again, thus moving the screw back over to the original hole.
How do you reset a motion sensor light?
Turn the switch on and check your lights. If this does not work, proceed to step two. Step 2: Turn your light switch on and off quickly, hitting each position four times. When the light comes on, turn the switch to the off position and wait five to seven seconds before turning it on again.
