How do you reset the timing belt light on a Isuzu 4jg2?
How do you reset the timing belt light on a Isuzu 4jg2?
The reset is done by taking the clocks out of the dashboard. On the back there is a small silver screw, towards the middle. About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole.
How do you reset the T-belt light on a 2011 Toyota Land Cruiser?
Follow the instructions below to reset the T-Belt Light on your Toyota Land Cruiser J200:
- Turn the ignition key to the “ON” position without starting the engine.
- Press the ODOMETER/TRIP button repeatedly until you see “ODO”
- Next, turn the ignition “OFF”
How do you reset Isuzu 4JG2 timing belt light?
The reset is done by taking the clocks out of the dashboard. On the back there is a small silver screw, towards the middle. About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole.
How do you turn off timing belt light?
About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole. That switches the light off, you leave it there then until you need to change the timing belt again, thus moving the screw back over to the original hole.
How to reset club Isuzu International International light?
IMG_1283.JPG Then the dash will come out a bit and remove the speedo cable. I find it easer to pop the dash pod a bit so i can get to the cable. Then unplug the wires on the dash Find the two screw holes marked KSW and move the screw from one side to the other. This will reset the light
How to replace masking tape in club Isuzu?
1. Remove the masking tape from the hole B. 2. Remove the screw from the hole A and install it to 3. Apply new masking tape to the hole A. being replaced for the first time (after 100,000 km). procedure. You do not have the required permissions to view the files attached to this post.
