Where is the relay on a blower motor?

Correction assuming 97 is same (probably is)… Fan relay is as posted before on top of the duct work left of the resistors you can see both behind the glove box if you take it out. The purple wire comes from the relay/resistors according to fan speed selected.

How does a blower motor resistor control the fan speed?

The blower motor resistor controls the fan speed of the blower motor and the resulting change in air pressure produced by the movement of the blower fan. It accomplishes this by regulating the electric current that powers the motor.

What are the symptoms of a failed blower motor resistor?

Blower motor resistor problems. Problems with a blower motor resistor are common in many cars. The most common symptom of a failed blower motor resistor is when the heater fan only runs at high speed and doesn’t work at low speeds.

What causes a blower fan to not work?

When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently. A blower fan is connected to the negative battery terminal (also called ground) on one end and to the positive battery terminal through a blower motor resistor on the other end.

Why is my blower motor resistor not working?

CLICK HERE TO RESET YOUR PASSWORD! Help! Fan quit working on all 4 speeds. AC light & recirc light still light up and AC compressor clutch engages when turning fan on in AC mode, but not getting the fan to work. I replaced the blower motor resistor and the control unit with new parts from rockauto (ACDelco).

How to test Honda Accord blower motor resistor?

Testing Honda power transistor (blower motor control module). For example, in the 2009 Honda Accord, the service manual describes the procedure as follows: Turn the ignition to ON. Press and hold the OFF button and within 10 seconds press and release the Window Defogger button five times.

Where is the blower motor resistor on a Mazda 5?

In many cars it’s fairly easy; the blower motor is located behind the glove box and held by 3-4 screws. In others it might be located inside the dash (e;g Mazda 5) which makes replacement difficult. If you need a proper diagnostic procedure, we posted several links where you can access a service manual for your car for a subscription fee.

Where can I get a new blower motor resistor?

I replaced the blower motor resistor and the control unit with new parts from rockauto (ACDelco). I’ve checked the fuse in the dash fuse panel and it is good.

Why does my blower resistor keep going bad?

Trent, one of the biggest reasons for blower motor resistors to have shorten life is actually because of faulty blower motor drawing too many amps, some times melting wires/plugs, heating up resistors shortening their life. Many Dodge forums tell of this problem.

What causes a fuse to blow on a blower motor?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

How to replace blower motor resistor in 2004 Silverado?

This is not a good video on how to replace the resistor for a Silverado Blower Motor. The video is less than 4 minutes and if it takes you that long to replace the resistor sub-assembly it has taken too long. I will try to make better movies in the future. IMPORTANT: Watch my short Video on the Letter I got from GM. Loading…

What happens when a blower motor resistor fails?

If you’ve replaced a blower motor resistor and that replacement has failed, it’s time to conduct an amperage test on the blower motor. If the amp draw exceeds manufacturer’s specifications, replace the blower motor. can also cause an overheating condition. In some cases, the heat is so high that it melts the connector.

What are the symptoms of a bad heater motor resistor?

Symptoms of a Bad or Failing Heater Blower Motor Resistor. 1 1. Blower motor stuck on one speed. A common symptom of a faulty blower motor resistor is a blower motor that is stuck on one setting. The blower 2 2. Blower motor does not work on certain settings. 3 3. No air from the vehicle’s vents.

Where does the purple wire come from on a blower motor?

The purple wire comes from the relay/resistors according to fan speed selected. The purple wire should have battery voltage ~ 12V when on hi. At low is might have 5V, M1 7 ish, and M2 9 ish volts. (note mine is not working and I think resistors are bad I get 11.9V on hi 11.73 v on all other speeds lo, m1, and m2.

How many volts does a blower motor have?

At low is might have 5V, M1 7 ish, and M2 9 ish volts. (note mine is not working and I think resistors are bad I get 11.9V on hi 11.73 v on all other speeds lo, m1, and m2. Anyone ever measure what voltages are normal to speeds ?

Why is the resistor not working on my blower?

Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.

Why is the blower motor not working on my car?

My car has an automatic transmission. Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.

Where is the relay on a blower motor?