How do you remove a rear axle cover?
How do you remove a rear axle cover?
Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket. Rotate the carrier until the pinion pin side with the 7mm bolt is facing down. Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing.
How do you remove a drive axle from a truck?
Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier. Use the needle nose pliers and just lift them off. Once they are off, pull both axles out of the housing and stand them up.
What’s the best way to disassemble a Chevy differential?
It depends on your preference and tools available. The first step is to use a socket and ratchet or a wrench to remove the cover bolts. Use a soft mallet to break the seal or use a pry bar, but be careful not to damage the mounting surface of the center section.
What’s the first step in disassembling a Chevy?
The first step is to suspend the chassis and let the rear extend freely under the car. Use the properly rated floor jack to jack up the car and place the correct jackstands under the frame rails. Remove the lug nuts and take off the rear wheels. The shocks are fully extended and can be unbolted.
How do you remove C-clips from axles?
Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing. Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier.
Where to put drip pan on rear axle?
Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket. Rotate the carrier until the pinion pin side with the 7mm bolt is facing down.
How to remove rear axle shafts with locking differential?
On axles WITH a locking differential, keep the pinion shaft partially withdrawn. 16. On axles WITH a locking differential, place the C-lock (1) on the axle shaft (3) so that the ends are flush with the thrust block (2) (Illistation # 8).
Can a Chevy 10 bolt differential be disassembled?
The disassembly procedure for both Chevy 10- and 12-bolt rear differentials is virtually the same. You do not need to be concerned with getting it out of alignment.
How to remove pinion seal from Chevy differential?
Pinion Yoke Removal 1 Remove Pinion Nut A fair amount of torque is required for removing the pinion nut. 2 Remove Yoke A few blows with a soft hammer usually gets the yoke free from the splines. 3 Remove Pinion Seal (Special Tool)
The first step is to suspend the chassis and let the rear extend freely under the car. Use the properly rated floor jack to jack up the car and place the correct jackstands under the frame rails. Remove the lug nuts and take off the rear wheels. The shocks are fully extended and can be unbolted.
