Can you install airbags in old cars?
Can you install airbags in old cars?
Drivers of older cars can now protect themselves with an airbag, thanks to a deal between airbag maker Breed Technologies Inc. and Midas International Corp. Breed has agreed to sell its SRS-40 retrofit airbags through Midas service shops in six U.S. markets.
How to install front airbags in a car?
Turn the steering wheel to gain access to each of the driver air bag module bolts or attachment pin bores. Remove all hardware as necessary. Disconnect wiring, horn wire, grounding strap, airbag connectors and any wire for radio, cruise or added steering wheel controls (as available).
Who is the best person to install airbags?
We recognize that installing airbags is best left to certified technicians or those who are qualified under the standards set by the automotive industry (ASE). If you use any of information from this web-site to install your airbags you do so at your own risk.
What happens if you install an airbag incorrectly?
Improperly installing airbags can cause accidental deployments and therefore serious bodily injury. Your first responsibility prior to starting the installation process is to disconnect the terminals from the battery.
How many ohms does it take to activate a front airbag?
The airbag requires only 2 – 3 ohms for deployment and touching the airbag terminals with your meter may provide enough current to activate the airbag. This warning applies to all airbag types, including but not limited to side airbags, roof airbags, knee airbags, foot airbags, seat airbags, etc.
Turn the steering wheel to gain access to each of the driver air bag module bolts or attachment pin bores. Remove all hardware as necessary. Disconnect wiring, horn wire, grounding strap, airbag connectors and any wire for radio, cruise or added steering wheel controls (as available).
Do you lay the airbag down or up?
It is important to lay it down vinyl side up because if it does accidentally deploy the energy of the airbag will only cause the airbag to open and no harm is done. However, if the airbag is set vinyl side down an accidental deployment will cause it to become a dangerous flying projectile.
We recognize that installing airbags is best left to certified technicians or those who are qualified under the standards set by the automotive industry (ASE). If you use any of information from this web-site to install your airbags you do so at your own risk.
The airbag requires only 2 – 3 ohms for deployment and touching the airbag terminals with your meter may provide enough current to activate the airbag. This warning applies to all airbag types, including but not limited to side airbags, roof airbags, knee airbags, foot airbags, seat airbags, etc.
