What is a kickdown linkage?
What is a kickdown linkage?
The Stock Torqueflite Kick-Down Linkage is a Huge Pain to Get Right. In lieu of a kick-down cable, the TorqueFlite uses a series of rods, bellcranks, levers, and brackets to initiate a downshift when the driver’s right foot gets heavy. This complex arrangement works remarkably well as long as a car is stock.
How do you install a kick down cable?
Method 1 of 1: Replacing the kickdown cable
- Materials Needed.
- Step 1: Jack up the front of the vehicle and set the jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Disconnect the kickdown cable at the carburetor or throttle body.
- Step 4: Remove the kickdown cable from the mounting bracket.
How to adjust the C6 kickdown linkage diagram?
Step 3: Install the trans cable bracket and . linkage is adjusted correctly, slide the kickdown throttle body fitting. The PO of my 79 never installed the C6 kickdown when he did the swap. I purchased a Lokar Parts Break-Out Diagram w/Nomenclature Source: by THROTTLE KICKDOWN LINKAGE ADJUSTMENT by ARRC (= to.
How do I hook up kickdown in Powerglide?
Powerglides don’t have cables, they use a lever system. Here’s a picture: http://vettes.com/PartsImages2/Transmission/CaAutoTransLink6367.gif. This is from a Corvette site, but they look similar. The front of the upper rod attaches to the carb throttle lever.
How to adjust the linkage on a 727?
The lever on the trans needs to be able to come fully forward when your throttle is closed. Measure your length of throw on the carb and the transmission linkage individually. Either you could move the pin further from your fulcrum on the carb bracket, or look for a kickdown lever on the transmission that is slightly shorter.
Do you get kickdown if you don’t get Wot?
You will not have kickdown if the throttle lever does not go fully rearward at WOT. If you use your current linkage, then if you set the trans lever so you do get WOT, then you will have delayed normal driving upshifts – but this may be acceptable to you as long as the normal shift points are not too delayed.
