What to do if your 4WD lights keep blinking?
What to do if your 4WD lights keep blinking?
You might pull the bezel out & check the switch connectors for corrosion & spray some contact cleaner or wd-40 inside the switch, then twist the switch several times to loosen any gunk inside. Need LED’s? Send me a PM LINKS…
Why are the 4WD lights blinking on my Ford Ranger?
THe shift switch has no effect on changing drive modes and the 4WD indicator lights are still blinking. A little googling yielded the meanings of the tree trouble codes: I thinking it’s got to the transfer case motor. A new motor is $100 -$130 and cannot be returned to most parts stores. Kind of an expensive gamble to buy one and swap it.
What does it mean when my 4×4 lights flash on my Ford?
The 4X4 indicator lamps may flash on some vehicles. This may be due to oxidation buildup and/or premature wear on the sense plate of the shift motor which can send incorrect signals to the 4X4 controller. Terminals on the transfer case connector may also develop a resistive film, leading to faulty signals to the 4X4 controller.
Can a 2WD truck go to 4WD High?
Per the owners manual I shifted from 2wd to 4wd drive while moving forward at less than 45mph while the wheels had traction. The truck went into 4wd high without a problem.
What are the blinking lights on my 4×4?
After about 4 hours of crawling on the ground, I figured out what is wrong with my 4X4 blinking lights. Problem: When switching from 2 WD to 4 WD hi or 4 WD low, the lights on the dash switches would start blinking, indicating a malfunction and also I had no 4 WD.
What does the blinking 4 wheel drive indicator mean?
So what is that 4 wheel drive indicator blinking on your dashboard means? The purpose of the 4 wheel drive light is to indicate when you have engaged 4WD mode by selecting 4H. When the light flashes continuously for more than 30 seconds it signifies there is a problem somewhere on your drivetrain system and that 4WD has not engaged properly.
Why are the dash lights blinking on my Chevy Colorado?
Problem: When switching from 2 WD to 4 WD hi or 4 WD low, the lights on the dash switches would start blinking, indicating a malfunction and also I had no 4 WD. I troubleshot the drive line and found that all was working, except for the front drive axle actuator, part #26060073, though this is what I thought.
Why are my 4hi and 4LO lights blinking?
Tonight while driving the 4×4 light and the 4Lo light both started blinking. I wasn’t even trying to switch between 2H and 4H when this happened. As of now my truck is stuck in 4 high. I tired switching back to 2 High and even into 4Lo.
