How does the starter stay engaged after the igition key?
How does the starter stay engaged after the igition key?
The starter motor stays engaged after the igition key It attaches to the small stud on the starter solenoid/relay: One other note: if you use a wire to connect power to the small stud (or a screwdriver can be held so it contacts the positive battery cable stud on the solenoid), the solenoid will engage the starter.
When does the starter stay engaged on a car?
The small wire should only be powered when the key is turned to the start position, but if it stays powered up in the run position, the starter will stay engaged. If the starter solenoid sticks, the starter will stay running until it unsticks, or until the battery is disconnected.
What causes a starter to turn off without a key?
At starter the smaller exciter wire is either getting voltage or the solenoid is stuck engaged?? Smaller gauge wire should have no power without key in “start” position but if it can get power from anywhere it will trigger the starter. Look again to see if something is touching or too close there.
How does a starter motor hook up to a negative terminal?
Re-installed the starter motor. When hooking up the new battery, I hooked up the positive side. When I touched the negative cable to the negative terminal, there were sparks, and the starter motor engaged and tried to start the engine. The keys were not in the ignition and the ignition was in the locked position.
Can you start a starter with the key off?
You’ll have to start tracing back from the solenoid and see where the harness is pinched or has a bare wire in it.. Thumb button shouldn’t work with the key off. So I say start at the solenoid and go from there.. Thanks cmanningjr, will do that 1st thing in the morning.
Where does the power go in a car starter?
You’ll see that power flows from the battery to the ignition switch. In the start position, power flows to a fuse and then to the transmission range selector (auto trans) or park/neutral switch (manual trans). If the transmission is in either Park or Neutral, power flows to the control coil portion of the starter relay.
Can a car start while in the run position?
If you find ground in the RUN position, check the ignition switch wiring for your year, model/engine the START wire is NOT hot while the switch is in the RUN position. Click on the jpg to download the wiring diagram of the starter circuit. Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period.
Why does the starter automatically engage on my Honda ATV?
Kinda seems like the thumbswitch is being held in. Swapped in the starter solenoid from my other 300, same thing. The ignition key is off during all of this too. Got frustrated and put the old bad battery back in, fired right back up 1st kick.
