How do you change steering rack bushings?
How do you change steering rack bushings?
Part 1 of 1: Replacing the steering rack bushings
- Materials Needed.
- Step 1: Disconnect the vehicle’s battery.
- Step 2: Remove the lower belly pans/skid plates.
- Step 3: Remove the driver side steering rack mount and bushing.
- Step 4: Remove the passenger side cross member bushing/mount.
How are steering rack bushings attached to the frame?
Unlike other mechanical bushings, the steering rack mounting bushings are engineered to move side-to-side as they are attached to the power steering rack and the vehicle frame.
How do you replace the rack mount bushings?
Any deflection in the bushings is cause for replacement. If you can see the rack sliding back and forth, even slightly, replace the bushings. Grasp the rack near one of the bushings and push and pull. Very minor, hardly noticeable movement is acceptable. Replacing rack mount bushings should be done in pairs, not singly.
How to remove and repair rack and pinion bushing?
1 Loosen and remove the bolts securing the rack to the frame member. 2 Remove the rack mount and set it aside. 3 Pull the old bushing out paying attention to any keyways or grooves in the bushing, mount, and the rack that are used to align the bushing and mount to the
How much torque do you need for a bushing rack?
Place the mount strap over the bushing and rack and thread the nuts/bolts back in by hand. Tighten the nuts/bolts to spec. Some bushing kits come with instructions that will list this torque spec, but a good standard is around 50 foot-pounds.
How are bushings installed on a steering rack?
The best way to install new bushings depends on the type of mount. On most vehicles, the driver side mount will be round. The passenger side mount will consist of two brackets with bushings in the middle of them (similar in design to main cap bearings for a connecting rod).
Place the mount strap over the bushing and rack and thread the nuts/bolts back in by hand. Tighten the nuts/bolts to spec. Some bushing kits come with instructions that will list this torque spec, but a good standard is around 50 foot-pounds.
How big are rack and pinion bushings on a Mustang?
Note: On some cars (Mustang IIs come to mind immediately), the rack and pinion mount and bushing are integrated with the rack itself. These bushings, when worn, require the rack to be removed and the mount bushings pressed out. When putting it back together, the rack-to-frame bolts are torqued to between 80 and 100 foot-pounds.
