How do you turn on the high beams on a 2010 Ford Focus?
How do you turn on the high beams on a 2010 Ford Focus?
To turn on your high-beam headlights, push the left lever attached to the steering wheel forward. An indicator on the console with display when your brights are on.
Why are the high beam lights not working on my Ford Focus?
The high-beam lights staying on on the Ford Focus is a common problem of Focus vehicles produced between 2000 and 2005. There two issues that might be causing this are the headlight relay being stuck and a bad headlight switch. The repairs are fairly simple and take less than 30 minutes.
Where are the high beam relays on a Ford Focus?
Open the fuse box located behind the battery. Remove the relays labeled “26” and “27.” These are the high-beam relays. Replace them with new 10A relays and place the cover back onto the fuse box. Close the hood. If the problem persists, then the issue is with the headlight switch. Turn off the engine of the Focus and open the hood.
Where is the headlight switch on a Ford Focus?
Turn off the engine of the Focus and open the hood. Remove the negative battery terminal with a socket wrench. Use a slotted screwdriver to push in the tabs on the left and right side of the steering column. This will release the top cover of the column. Remove the cover to access the headlight switch.
The high-beam lights staying on on the Ford Focus is a common problem of Focus vehicles produced between 2000 and 2005. There two issues that might be causing this are the headlight relay being stuck and a bad headlight switch. The repairs are fairly simple and take less than 30 minutes.
What happens when you pull the high beam lever?
When Hi Beam lever is pulled high beams come on but will not stay on when lever is released. They go back to dim. Switched hi and low relays with each other and problem stays. Switched wit … read more I have a 2000 Ford Ranger and both low beam headlights went out at the same time.
Open the fuse box located behind the battery. Remove the relays labeled “26” and “27.” These are the high-beam relays. Replace them with new 10A relays and place the cover back onto the fuse box. Close the hood. If the problem persists, then the issue is with the headlight switch. Turn off the engine of the Focus and open the hood.
Why are the low beams on my F-250 not working?
F-250: cannot drive..relay located for the low beams on this model? Just purchased an 02 F-250 and cannot drive it home from the lot (which is now closed) b/c the low beams will not work. Where is the relay located for the low beams on this model? … read more
