How do you install a fan clutch?
How do you install a fan clutch?
Part 1 of 1: Replacing your fan clutch
- Materials Needed.
- Step 1: Checking your fan clutch for problems.
- Step 2: Remove the fan shroud.
- Step 3: Remove the fan.
- Step 4: Rock from side to side.
- Step 5: Remove the bolts.
- Step 6: Install the new fan clutch.
- Step 7: Tighten the bolts.
How do you install a new fan clutch?
Secure the fan on a work table with plenty of room to work with the fan shaft facing your direction. There are four large bolts in the center of the fan assembly that hold the clutch in place. Remove these bolts and the clutch will be free from the fan. Step 6: Install the new fan clutch.
How do you replace a clutch in an AC system?
To replace the electric clutch in any air conditioning system, the whole air compressor needs to be replaced. Find out what kind of air compressors are compatible with your vehicle and buy a replacement. Open the hood and allow the engine to cool completely before you start working on the car.
When do you know it’s time to replace the fan clutch?
According to Hayden, here are some signs your fan clutch might need replaced: Fan spins excessively when engine is stopped (three or more times when hot engine is shut off). Poor A/C performance at idle or low vehicle speeds. Fan speed does not increase when engine is hot.
How to install a fan on an ec450tm fan clutch?
1. Install the fan onto the Horton EC450TMFan Clutch. Be sure the fan is installed for the correct rotation. Alternately and evenly tighten the Hex head nuts provided in the kit (See Page 15 for Torque Specifications). NOTE Do not loosen the P-clamp attaching the wiring harness to the metal tab on the Fan Clutch.
How do you remove a clutch from a fan?
There are four large bolts in the center of the fan assembly that hold the clutch in place. Remove these bolts and the clutch will be free from the fan. Step 6: Install the new fan clutch. Hold the new fan clutch in place aligning the bolt holes in the same place as the old clutch.
How do you install a new AC clutch?
Insert the new pulley, and engage the snap-ring with the beveled edge facing outward. Install one spacer on the compressor shaft, then install the clutch, and fasten the 6 mm bolt securely. Place the feeler gauge between the clutch and the pulley to ensure proper clearance.
What are the different types of fan clutches?
Types of Fan Clutches. The main types are non-thermal, thermal, and electronic — all of which use a silicone fluid to engage and disengage your fan. Non-thermal clutches operate solely based on the shaft speed of the water pump. At low and idling speeds, the clutch allows the fan blade to turn at almost a 1:1 ratio.
According to Hayden, here are some signs your fan clutch might need replaced: Fan spins excessively when engine is stopped (three or more times when hot engine is shut off). Poor A/C performance at idle or low vehicle speeds. Fan speed does not increase when engine is hot.
