Why does my focus engine mount make noise?
Why does my focus engine mount make noise?
The rubber at the bottom of the mount and the bolt seem okay, but inside was full of rust and oily water. The increase of noise was only minimal, but I’m at a loss about how to proceed. Is there a secondary cause to all of this, or did I get three bum parts. HELP!!!!!! did you buy this mount from the same place over and over? Try a different brand.
What should I do if I hear a thumping noise on my brakes?
Do this three to five times, while keeping a steady speed; the noise should disappear, or at least be 90% gone. Then drive the car at normal speeds and use the brakes the way you normally would. If the noise has not changed, you may have a different thumping noise than what I have described here in this article.
What kind of Mount does a Ford Focus use?
The OEM mount is the only one that works for the front mount on early Foci. The other mounts are acceptable from aftermarket sources. Had bought the 2010 ford focus only after a 1year and so the egine mount went, first signs of this was a crunch noise when turning then started to occur when pulling away.
How much does it cost to replace motor mount on Ford Focus?
Just replaced the pass side motor mount yesterday. $107 at the dealership. That’s not a bad price If it lasts another 7 or 8 years. Get the Ford mount. To fix this problem you will need to replace both the upper Passenger side mount and the lower back torque strut mount (Dog Bone).
The rubber at the bottom of the mount and the bolt seem okay, but inside was full of rust and oily water. The increase of noise was only minimal, but I’m at a loss about how to proceed. Is there a secondary cause to all of this, or did I get three bum parts. HELP!!!!!! did you buy this mount from the same place over and over? Try a different brand.
Are there any problems with the Ford Focus?
Instructor, Ohio Technical College, Cleveland, OH Every vehicle has it fans and its detractors, and every vehicle has its strong points and weak points. While the Ford Focus is no exception, it does soldier on and remains a popular vehicle. That means it will likely come into your shop with its own set of problems.
The OEM mount is the only one that works for the front mount on early Foci. The other mounts are acceptable from aftermarket sources. Had bought the 2010 ford focus only after a 1year and so the egine mount went, first signs of this was a crunch noise when turning then started to occur when pulling away.
What to do if you have an electrical problem with your Ford Focus?
Apply the dielectric grease to the connector to prevent any repeat performances of the problem. Dielectric is critical for the longevity of almost any electrical repair on a vehicle. Skipping the dielectric grease will cause the car to come back in the future. [PAGEBREAK]
