What kind of steering shaft does a Mustang have?

No setscrews to loosen! The top adaptor stub is secured to the stock steering column just like the original shaft, making installation a breeze. MM makes a Hybrid Steering Shaft Assembly that allows the installation of an SN95 (1994-2004) power steering rack into a Fox (1979-93) chassis Mustang.

Where are the hose ends on a power steering rack?

The pressure port in the rack is the 1/2-20 port. The kit comes with 90o hose ends. Work out your hose routing and decide where to use each hose end (extra hose ends and hose are available). The diagram shows the general routing of a power steering system.

How to hook up a power steering pump?

1) Adapter, -6 to 1/2-20 2) Adapter, -6 to 5/8-18 1) Hose Clamp 3’ S.S. Braided Teflon Hose Your HEIDTSHot Rod Shop Power Steering Hose Kit is used to hook up a GM power steering pump to a Mustang II power rack & pinion. This kit contains fittings and hose to complete a basic hook up in a typical installation.

How big are the bolts on a Ford Mustang?

Or? the TFI module bolt is M4 x 10mm screw. The stock ones have a 6mm hex head with an 8mm (OD) washer under the head. The bore diameter in the TFI plastic housing is 9mm. 5/16-18 x 1 1/4″ for bottom right bolt, both bolts use split lock washers. Flywheel bolts 7/16-20 thread.

How big are valve cover bolts on a Ford Mustang?

Valve cover bolts are 1/4-20, intake bolts, water pump and timing cover bolts are 5/16-18, header bolts are 3/8-16, motor mount and bellhousing bolts are 7/16-14.

How big is the clutch mount on a Mustang?

Transmission Mount to Transmission= 1/2″ X 13 X 1-1/2” long. Clutch Fork Cover Bolt Size—- 6mm x1.0 with 8.8 Hex Head ( or it’s nothing much more than a small course-thread sheet metal screw with an 8mm head).

What kind of steering shaft does a Mustang have?