Where is the ignition switch on a Ford Thunderbird?
Where is the ignition switch on a Ford Thunderbird?
Place the battery cable bolt through the battery negative cable terminal and tighten to 60 to 90 lbs. Install the seat and test the ignition. Hold the new ignition cylinder in your left hand and slide the ignition key into the ignition cylinder. The switch is on the backside of the cylinder housing on the Thunderbird.
How do you change the ignition switch on a Harley Davidson?
Place the new Harley ignition switch on the console, where the old one was. Line up the screw holes. Insert the four screws and get them started in their holes. Tighten the screws, in a crosswise pattern, turning each screw a little at a time until tightened. Connect the light/key switch wire to the ignition.
Where is the wire on an ignition switch?
The final step is connecting the ignition wire to the ignition terminal located on the ignition switch. The IGN terminal powers vehicle ignition, wipers, accessories and other operating features.
What does the St terminal on an ignition switch do?
The “ST” terminal only activates when the ignition switch is turned to the “START” position and is a spring-loaded momentary contact. Connect the ignition wire to the “IGN” terminal of the ignition switch. This is the main terminal that is used for vehicle ignition, wipers, accessories and other operating features.
What kind of wiring does a 1955 ignition switch use?
IGN – #16 red wire with green attaches to the coil on a 1955 and to the ignition resistor on a 1956/57, #30A,30B black with green wire attaches to oil pressure and generator light. The eyelet is single with the wires clustered together.
Where are the terminals on an ignition switch?
The back of the ignition switch has four terminals, which are the Battery, Start, Ignition and Accessory. The procedure for wiring an ignition switch is as follows: To begin with, the negative battery terminal must be disconnected before locating the positive power lead to the switch.
Where can I find the 1956 ignition manual?
The manual has been reproduced and is available from CTCI, item number110-25. The wiring is correct but the drawing of the back side of the ignition switch for the 1955 on page 18 and the 1956 on page 57 is not correct.
Where is the starter relay wire on a ignition switch?
The starter relay wire needs to be connected to the Start terminal located on the ignition switch. The final step is connecting the ignition wire to the ignition terminal located on the ignition switch.
