What kind of cylinder head does a Ford truck use?
What kind of cylinder head does a Ford truck use?
Like the 289 heads mentioned earlier, all 302 heads are the same except for Thermactor provisions. There’s also a truck head (C9TE-C), which employs a 58.2-cc chamber for slightly higher compression.
How many variations of the Ford 3.8L engine?
There have been four different variations of the crank used in the 3.8L over the last 17 years. There’s also a new casting in 2001 that we haven’t seen yet, so there may be a fifth one. Each one is unique, but some of the early ones can be converted into the later ones with a little machining.
When did Ford change cylinder heads and valvetrains?
Beginning May 2, 1966, Ford changed both cylinder heads and valvetrains on 289 engines. Prior to this date in production, Ford had pushrod guide holes machined into the castings. However, from May 2, 1966 on, Ford found a cheaper way to make 289 engines.
What kind of cylinder head does a Ford 221 have?
The 221 cylinder head is identifiable at a glance by observing its small kidneyshaped 45- to 51-cc combustion chambers along with 1.59/1.39-inch intake/exhaust valves. These heads are casting numbered C2OE or C3OE and are identical in appearance. The 260 heads have larger 52- to 55-cc kidney-shaped chambers with the same valve size.
How to identify small block Ford cylinder heads?
Small-block Ford cylinder head identification is easy if you take the time to understand Ford castings. The most important clues are casting numbers and date codes. You also need to understand the difference between a casting number and part number; they are rarely the same. Begin with the Ford casting number, then look for the date code.
What kind of cylinder head does a Ford 289 use?
This makes it a good cylinder head for any 289/302 Ford if you want to pump up the power a bit. Otherwise, the 4V head has the same size valves and ports as the 289. The 302-2V head for 1968 has larger 63-cc chambers to lower compression and reduce emissions. Look for C7OE-C, C7OE-G, C8AE-J, C8DE-F, C8OE-J, C8OE-M, C8OE-K, and C8OE-L.
Beginning May 2, 1966, Ford changed both cylinder heads and valvetrains on 289 engines. Prior to this date in production, Ford had pushrod guide holes machined into the castings. However, from May 2, 1966 on, Ford found a cheaper way to make 289 engines.
What are the dimensions of a Ford 3.8L engine?
The dimensions of the rods and the mains on the Ford 3.8L were almost the same as the ones on the Buick 3.8L, although they actually ended up being the same diameter as the ones in the 351 Windsor.
