Does the 2005 Ford Explorer have transmission Problems?
Does the 2005 Ford Explorer have transmission Problems?
Unfortunately, transmission failure was a very common problem with many 100,000 miles of 2005 Ford Explorer vehicles. The problem was resolved by either rebuilding the transmission or installing a new one. The average repair cost for transmission failure was about $2,880.
What year Ford Explorers have transmission Problems?
Transmission failures and problems are unfortunately very common with Ford Explorers, particularly those produced in 2002, 2003 and 2004. The cost of a repair can be enormous, especially if you have it done by a dealership.
What type of transmission does a 2005 Ford Explorer have?
Used Transmission
| Year | 2005 |
|---|---|
| Model | Explorer |
| Options | AT (4 Dr) exc. Sport Trac 6 cylinder (4.0L) 4×4 |
| Transmission Tag | 4L2P-BB, 4L2Z-BBRM, 6L2P-FA, 6L2P-FB, 6L2P-FC, 7L2P-DA, 7L2P-DB, 8L2P-KA |
| Transmission Code | 5R55S |
What’s the problem with the Ford Explorer transmission?
Purchased Explorer about 8 months ago. Car itself is is very nice condition, low miles for the model year. 2 months after purchase the transmission started to jerk when shifting into 3rd gear, not all the time and not terrible at first. Now, however, it has quit shifting into overdrive along with the hard 3rd gear shift.
What to do if your Ford Explorer stops shifting?
Now, however, it has quit shifting into overdrive along with the hard 3rd gear shift. Checked the internet to find that transmission problems with Explorers is fairly common. Called local repair shop. They told me the only fix is rebuilding the transmission and installing a steel sleeve where the shaft wears on the aluminum case. Cost – $3500.
What causes Ford Explorer to jerk when accelerating?
When one has gone bad, they’ll usually cause your Explorer to jerk when accelerating, idle rough, and hurt fuel mileage. Here’s more on diagnosing bad coil packs. Plug Wires – Spark plug wires are not as common as they used to be, but your particular model of Explorer may have them, so they are on the list.
What causes no 2nd gear on Ford 4R55E?
A low reading means that there is most likely a short in the internal wiring and no reading means the wire is broken. In either case, the solenoid will need to be replaced with a new one. 2) No 2nd or 4th gear: This is often caused by the solenoid regulator valve being out of position.
What kind of transmission does a Ford Explorer use?
Ford Automatic Transmission Application Guide Model Years Engine Type / Size TYPE EXPEDITION 2007-2008 V8 5.4L 6R75/80 EXPLORER 95-96 V6 4.0L 4R55E EXPLORER 96-01 V8 5.0L 4R70W EXPLORER 97-01 V6 4.0L 5R55E
When one has gone bad, they’ll usually cause your Explorer to jerk when accelerating, idle rough, and hurt fuel mileage. Here’s more on diagnosing bad coil packs. Plug Wires – Spark plug wires are not as common as they used to be, but your particular model of Explorer may have them, so they are on the list.
A low reading means that there is most likely a short in the internal wiring and no reading means the wire is broken. In either case, the solenoid will need to be replaced with a new one. 2) No 2nd or 4th gear: This is often caused by the solenoid regulator valve being out of position.
Why does my transmission jerk when I shift gears?
Transmission fluid that has aged and lost some of its frictional properties can also lead to poor shift quality. When your vehicle’s computer tells the transmission to shift gears, hydraulic pressure (provided by the fluid) squeezes a series of plates together inside a clutch pack…
