Why does the 4×4 indicator light keep flashing?

The lights on the 4×4 indicator (switch) will flash in a pattern, there are only 4 codes, one flash is code one, 2 flashes is a code 2, and so on… Code “1” is “RAM standby power” and is considered normal, may be caused by clearing the codes.

Where is the blinking 4 wheel drive light?

Pull the front axle actuator. Its on the pass side of the pumpkin, on the extension housing. Back side, near the top. Has two wires connected to it, and a big hex. Disconnect the wires, and pull the actuator. Hook the wires back up. You can measure the length from the flange to the inside end of the actuator, or just eyeball it. Turn the key on.

When does the selected position indicator light stop flashing?

The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON. If any of the shift conditions are not met, the indicator position light will continue to flash. You cannot be in gear for it to work.

Why is the ABS light blinking on my 4×4?

An expert who has achieved level 1. An expert that has 1 follower. An expert whose answer got voted for 2 times. I have the same problem with one addition – when I try to engage the 4X4 the ABS light comes on also. Sometimes when the engine starts and the ABS light goes off as normal the 4X4 will engage. What was the final solution.

Why is the 4 wheel drive light blinking?

The 4-Lo engaged the low-range transfer case for rough and challenging off-road driving. Fast forward a few decades and, enter the Actuator. The actuator is a component found mostly on modern four wheel drives and is designed to electronically engage 4 wheel drive.

What kind of wiring is in a 1985 Chevy Blazer?

WIRING INFORMATION: 1985 Chevy S-10 Blazer WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT RED Ignition Harness STARTER YELLOW OR PURPLE Ignition Harness IGNITION PINK Ignition Harness ACCESSORY ORANGE Ignition Harness POWER DOOR LOCK (5-wire reverse polarity) LT.

Why are there no lights on my 4WD?

2006 silverado 1500. 4×4 would not engage on mine. I would receive service 4wd message on dash and 4wd switch would change light locations randomly. Changed swich and it did not fix the problem.

What are the warning lights on a Chevrolet?

The following are warning lights and indicators found in vehicles built by Chevrolet. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray). There are nearly 50 of them so search carefully!