Do you need to replace the airbag control module?
Do you need to replace the airbag control module?
Additionally, you might be able to replace the airbag control module with some basic tools and know-how, thereby saving you more money on the labor costs. Once the replacement of the airbag control module is complete, you may also need your diagnostic tool to reset the codes and turn the SRS warning light off.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
Can a Nissan airbag module be reset by myairbags?
The best part of having your Nissan’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
What is data stored in airbag control module?
The airbag control module also determines if the airbags should remain intact during an incident. Inside the airbag control module data is stored that is calculated during an event. This information includes seatbelt usage, brake use, throttle position and vehicle speed.
When does my airbag module need to be replaced?
This all needs to be done to restore the car to its factory condition and have it drive properly. If your airbags did not deploy during the accident, that should be an indication that an SRS airbag module is not needed. You can choose to reprogram your SRS airbag module yourself.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
What happens to your airbag control module in an accident?
Send your airbag control module to MyAirbags and save time, money and not having to deal with a dealership! During an accident, seat belt retractors and tensioners are deployed and will lock up by their gas charges, similarly to how airbags are deployed in a collision.
