Where is the transmission sticker on a Ford truck?

Where is the transmission sticker on a Ford truck?

Check the sticker on the driver’s side door jamb to identify the truck’s transmission. The transmission field is circled in the figure below. Decipher the code using the following table. Figure 1. All Ford trucks come with an info sticker in the driver side door jamb. Turn your truck off and look at the instrument panel.

What kind of gears do I need for my Ford F 350?

The following gears, lockers and install kits are available for 2008 to 2010 Ford F-250 and F-350 Super Duty trucks with Dana 60 front axles and Ford Sterling 10.5″ rear axles. Note: Ford 10.25″ long pinion gears are also compatible with the Ford 10.5″ axle when a Ford 10.25″ master install kit is used.

How to change the transmission on a Ford F-250?

Use a screwdriver to lift the tab above the connector so that it can be turned and removed. Remove the screw holding the wiring harness in place and pull the harness out of the way. Pull the retaining clip off the solenoid, and slide the EPC out. Slide in the new EPC, replace the clip and harness, screw, and o-ring. Figure 3.

Why is my Ford F-250 shifting too hard?

If the shifter doesn’t line up correctly with the letter “D,” the screws in the shifter mechanism might be loose. On top of the steering column there is a flange with two torx bolts that can be found if you move the shifter. Check to make sure those bolts are tight. Next, check the plastic adjusted located underneath the dash.

Is there a transmission package for a Ford truck?

For those that have either had a complete failure of the transmission or its simply time for an upgrade, we also offer complete transmission packages in various levels depending on the horsepower and use of the truck.

What kind of transmission does a Ford F250 have?

This unit is used in Ford F250, F30, F450, and Super duty trucks from 1987-94. The Super duty model has a mechanical park brake assembly mounted to the extension housing. The S542 is found behind 300, 302, 351, 460, and diesel power plants.

What’s the transmission number on a Ford truck?

Top loaded heavy-duty 4-speed transmission with cast iron case and shift cover. Case casting number is 1309. Easily confused with T18, but the T19 is synchronized in all forward speeds. The T19 has a single step reverse idler gear while the T18 has a 2 step reverse idler.

Where are the 3 shift rails on a Ford truck?

Three shift rails mounted to the left side of case. This unit was produced for cars also but with lighter duty bearings and gear train. Produced in 2 and 4 wheel drive versions. Also known as Single Rail Overdrive (SROD).