What kind of axle does a Bronco Dana 44 use?
What kind of axle does a Bronco Dana 44 use?
One of the most common Dana 44’s swapped in to a Ranger is the early Bronco (EB) Dana 44. It’s desirable because the axles width is similar to that of the Ranger and also uses a coil spring/radius arm suspension similar to a Ranger.
When did the Dana 44 front axle come out?
The Dana 44 became available in the early Ford Bronco’s from 1971-1977. Axles prior to that point were the Dana 30. One of the major drawbacks of an early Bronco Dana 44 is it’s small 260x u-joints. You can find a stronger replacement shaft or a complete set of replacement shafts that use larger u-joints at companies like broncograveyard.com.
How big is the axle shaft on a Bronco?
You’ll need to replace the axle shafts in order to swap to a larger u-joint. The early Bronco driver side shaft is 18-5/16 inches and the F-150 shaft is 18-5/8 to 18-29/32 inches long. It’s common for the F-150 shaft to be used on the early Bronco drivers side.
How is the Dana 44 TTB attached to the frame?
The inboard ends of the beams are attached to a frame-mounted crossmember by a bushing, while the outboard ends support the steering knuckles and are attached to the frame through the springs and radius arms. The Dana 44 TTB (Twin Traction Beam) was used in the front of Ford F-150’s and Ford Bronco’s from 1980-1996.
What was the front axle on a 1971 Ford Bronco?
If you see “EB Dana 44”, then their talking about the Dana 44 front axle found in the 1971-1977 Ford Bronco. The Dana 30 and Dana 44 are both standard cut low pinion designs with small 260x u-joints. Although the Ford F150 came with the larger 297x u-joints, the 1966-1977 Ford Bronco never received them.
One of the most common Dana 44’s swapped in to a Ranger is the early Bronco (EB) Dana 44. It’s desirable because the axles width is similar to that of the Ranger and also uses a coil spring/radius arm suspension similar to a Ranger.
The Dana 44 became available in the early Ford Bronco’s from 1971-1977. Axles prior to that point were the Dana 30. One of the major drawbacks of an early Bronco Dana 44 is it’s small 260x u-joints. You can find a stronger replacement shaft or a complete set of replacement shafts that use larger u-joints at companies like broncograveyard.com.
What was the front end of a 1976 Ford Bronco?
66-77 Broncos came with the Dana 30 (66-71 1/2) and the Dana 44 (71 1/2-77). In 1976, Ford equipped the Dana 44 with disc brakes. The easiest way to identify which front end you have is to look at the steering knuckles. The Dana 30 uses king pins which are held in with four bolts on the top and bottom.
