How do you replace the rear pinion seal on a Ford Ranger?

Chock the front tires and place truck in park and set parking brake. Then using the rear differential as a jacking point, jack the rear-end of the truck up to desired height and place jackstands under axle at U bolts and remove the jack. Now using the 12mm 12-point socket, 1/2″ drive ratchet and pipe extension, loosen the driveshaft bolts.

What’s the best way to replace a pinion seal?

Step 2: Mark the pinion shaft, nut, and flange in relation to each other to reinstall in the same position. Then remove the pinion nut. Step 3: Use the puller to remove the flange from the pinion shaft, its very important to have a tapered end when pushing on the pinion shaft or the threads will be mushroomed.

How do you remove seal on ranger station?

That’s ok, you can use a chisel and hammer to collapse the seal inward. Catch the outer edge of the seal with the chisel and work your way around the seal until the seal puller can remove the seal or it simply falls out. Try your best not to damage the housing doing this.

What happens if a pinion seal fails on a differential?

As long as the pinion seal is in place and performing well, the differential will stay in good shape and operate as it is supposed to. A failed pinion seal can result in a minor leak where fluid seeps out, or a major leak that can ruin the differential bearings and gears.

Can a rear differential pinion seal be replaced?

I purchased a seal that was for my truck but once i got my seal out it turned out my truck did not have the standard 1/2 axle in it. It seems to be that it has been swapped out for a 1 ton limited slip rear end. it’s been a week after doing the project and all seems to be good there isn’t any leaks at all what so ever. Loading…

What’s the best way to install a pinion seal?

Position the seal according to how it needs to be installed against the axle housing. With the seal in position, begin tapping on a seal edge to begin seating it. When tapping, tap in a cross pattern so you are installing the seal as evenly as possible. Doing this will prevent any damage to the new pinion seal.

What happens when a pinion seal goes bad?

A failing pinion seal will leak which can ruin the differential. Average rating from 31 customers who received a Pinion Seal Replacement. The pinion seal, also called a pinion shaft, is designed to keep oil in and any water, dirt or debris out.

How do you change a front axle in a Ford Ranger?

3) Use a wire brush to clean the area around the differential. This will help prevent dirt from contaminating the differential housing while the cover is removed. 4) Position a drain pan under the drive axle. Loosen and remove all but two of the cover retaining bolts.

How much does it cost to replace front crankshaft seal on Ford Ranger?

Upfront and transparent pricing. Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. Ford Ranger Front Crankshaft Seal Replacement costs $249 on average. What is the Front Crankshaft Seal all about?

How to check front axle fluid in Ford Ranger?

The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models. To check the fluid in these differentials, you have to remove the fill plug on the drivers side of the differential.

How do you change the oil in a Ford Ranger?

Although some fluid can be removed using a suction gun, the best method is to remove the axle housing cover (if equipped) to ensure that all of any present contaminants are removed. As with any fluid change, the oil should be at normal operating temperature to assure the best flow and removal of fluid/contaminants.

How do you replace the rear pinion seal on a Ford Ranger?