Why are the windows not working on my Chevy Colorado?
Why are the windows not working on my Chevy Colorado?
Trying to narrow down the possibilities. If all controls are not working it could be a power supply problem. If only one side of the truck is inop, it could be a ground issue. When the windows are not operating, do the door locks still function, using the switches?
What to do if your drivers side window is not working?
Check and replace the fuses if it’s doing nothing and not making any noises.. Don’t let someone talk you into parts you don’t need. Then check to see if the buttons make any noise, even though they don’t roll the window up or down. A noise means the window regulator motor is fine, but the window regulator is shot.
How to fix a 2005 Chevy Colorado door lock?
Click to expand… I also have a 2005 Chevy Colorado with the exact same problem. I followed the advice given, that is removing the negative battery cable and holding it against the positive terminal on the battery for 30 seconds to completely discharge the BCM (body control module) and waiting 6 hours then reconnecting the battery cable.
Where is the PWR fuse on a Chevy Colorado?
The positive side of the circuit, for both left and right doors, starts with the 30A PWR/WINDOW fuse. The wires for both sides exit at the same terminal in the connector at the fuse box. As the problem affects both sides, the problem should be somewhere before the point that the circuits separate at the fuse box.
What’s the problem with the power window on a Chevy Colorado?
The HVAC recall is all fixed. What the drivers window does it when I use the auto roll up, the window will go 1/4 of the way up and go back down. It usually takes me about three tries to get the window to roll up completely. Minor, but annoying.
What to do if your driver side window does not work?
Shut the truck off and start again. Put in gear and you should hear the door locks activate again and your driver side window should work again. If that doesn’t do the trick, unplug the black harness again (with the ignition off), spray wd40 into any connection that has corrosion and blow connection clean with air.
Why does my Colorado window lock not work?
The resistor and connector is an easy fix with the link ssgjurista gave you. I think the problem is the contacts between the two most times rather than the resistor itself.
Is the drivers side window working on the Chevy Equinox?
The first generation of the Chevrolet Equinox, a crossover SUV from Chevrolet based on General Motors’ Theta platform. Drivers side window goes on sporatically when pressing the automatic window button on console all other windows work fine what could it be .chevy equinox 2005
Where is the relay on a canyon four door?
Same thing happened to my 04 Canyon four door after I disconnected the battery to replace the vent solenoid for the charcoal canister. There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch.
Why is my GMC Canyon crew cab not working?
To find out once it crapped out, my 2006 GMC Canyon Crew Cab had the original battery. I replaced it last week with a brand new battery. Over last summer the battery went dead from sitting around for long periods of times. Thats when we found out the power door locks and drivers window wouldnt work.
How to re-connect driver side power window controller?
3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5. Place the key in the ignition and turn to the run position 6. Connect Battery starting with the negative cable (ensuring not to connect then disconnect, (one swift motion)
Same thing happened to my 04 Canyon four door after I disconnected the battery to replace the vent solenoid for the charcoal canister. There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch.
To find out once it crapped out, my 2006 GMC Canyon Crew Cab had the original battery. I replaced it last week with a brand new battery. Over last summer the battery went dead from sitting around for long periods of times. Thats when we found out the power door locks and drivers window wouldnt work.
3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5. Place the key in the ignition and turn to the run position 6. Connect Battery starting with the negative cable (ensuring not to connect then disconnect, (one swift motion)
Where is the power window on a Chevy Colorado?
It is located in the engine bay, on the left side aft of the battery. Remove the one attach bolt and clean the mating surfaces of the box tab and the fender wall and remount the box. You don’t need to open the box at this time, but it wouldn’t hurt to check in there for corrosion.
Are there any problems with Chevy Colorado door locks?
When I reconnected battery, I used key started truck and at 20 mph the locks worked like normal. 😆 GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups.
Are there any problems with my Chevy Colorado?
GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups. The problem shows up as inoperative or intermittent door locks or power window operation.
Trying to narrow down the possibilities. If all controls are not working it could be a power supply problem. If only one side of the truck is inop, it could be a ground issue. When the windows are not operating, do the door locks still function, using the switches?
When I reconnected battery, I used key started truck and at 20 mph the locks worked like normal. 😆 GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups.
It is located in the engine bay, on the left side aft of the battery. Remove the one attach bolt and clean the mating surfaces of the box tab and the fender wall and remount the box. You don’t need to open the box at this time, but it wouldn’t hurt to check in there for corrosion.
GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups. The problem shows up as inoperative or intermittent door locks or power window operation.
Is the drivers side window stuck in a 2015 Chevy Cruze?
My husband rolled down his drivers side window this morning and it will not roll back up. It’s a 2015 so shouldn’t be an issue yet, but unfortunately it is. He can hear the motor for the window, but the window is stuck down in the door.
Why is my window fuse not working on my Chevy Colorado?
Check the 30A PWR/WINDOW fuse and socket for possible corrosion. Maybe try using some contact cleaner and a new fuse. Make sure that the fuse fits tightly in the contacts. Still having problems with windows. Seems worse, probably cause of warmer temp.
What to do if your passenger side window is stuck?
I just saw one with both the passenger and driver’s side windows off the track this last week. You’ll need to take the door panel off and most likely replace the regulator, although sometimes you can put the window back on the track without having to replace it. Look for the broken bits of plastic that hold it in place.
Check the 30A PWR/WINDOW fuse and socket for possible corrosion. Maybe try using some contact cleaner and a new fuse. Make sure that the fuse fits tightly in the contacts. Still having problems with windows. Seems worse, probably cause of warmer temp.
Is there a problem with the driver side power window?
I took my 2016 Z71 CC in for the HVAC recall and mentioned how the driver side power window doesn’t always work (Since I read someone else was having the same problem on the forum) and the guy didn’t believe me!
The positive side of the circuit, for both left and right doors, starts with the 30A PWR/WINDOW fuse. The wires for both sides exit at the same terminal in the connector at the fuse box. As the problem affects both sides, the problem should be somewhere before the point that the circuits separate at the fuse box.
Why are the locks not working on my Chevy Colorado?
Anyhow, turns out my battery was fine, but when I reconnected it the driver’s side window would not go up or down, and the power locks would not work. Pressing either button on the key fob would flash the headlights, and you could hear a relay under the hood clicking, but nothing on the locks.
What to do if your power window switch is not working?
As the problem affects both sides, the problem should be somewhere before the point that the circuits separate at the fuse box. Check the 30A PWR/WINDOW fuse and socket for possible corrosion. Maybe try using some contact cleaner and a new fuse. Make sure that the fuse fits tightly in the contacts.
What was the problem with my 2005 Colorado Crew Cab?
It’s also worth mentioning that I also had the ECM fail in my 2005 Colorado LS crew cab, which was causing that loss of power problem and it had to be replaced ($800), so GM is known to make sh–ty control modules. It is your truck and your nickel. Let us know how it works out.
How to fix driver side power door lock?
1. disconnect the battery and connect both the positive and negative cables together(after disconnected)) 2. disconnect the window and lock controller in the driver’s side door. 3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5.
Click to expand… I also have a 2005 Chevy Colorado with the exact same problem. I followed the advice given, that is removing the negative battery cable and holding it against the positive terminal on the battery for 30 seconds to completely discharge the BCM (body control module) and waiting 6 hours then reconnecting the battery cable.
1. disconnect the battery and connect both the positive and negative cables together(after disconnected)) 2. disconnect the window and lock controller in the driver’s side door. 3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5.
How to re-connect power door lock and driver side power window?
Re-connect door window controller and locks wiring harness 5. Place the key in the ignition and turn to the run position 6. Connect Battery starting with the negative cable (ensuring not to connect then disconnect, (one swift motion)
Where are the power locks on my car?
There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch. It can get stuck open, either from the BCM sending it into safe mode or, in my case, I think, because of extreme cold.
Anyhow, turns out my battery was fine, but when I reconnected it the driver’s side window would not go up or down, and the power locks would not work. Pressing either button on the key fob would flash the headlights, and you could hear a relay under the hood clicking, but nothing on the locks.
Re-connect door window controller and locks wiring harness 5. Place the key in the ignition and turn to the run position 6. Connect Battery starting with the negative cable (ensuring not to connect then disconnect, (one swift motion)
There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch. It can get stuck open, either from the BCM sending it into safe mode or, in my case, I think, because of extreme cold.
What happens to the battery in a Chevy Colorado?
The part I love is how the truck always dings and throws battery is codes when its cold out, and how the truck goes from 1/2 a tank to empty when you tap the brakes of shift into neutral.