How do you reset the computer on a 1998 Ford Explorer?
How do you reset the computer on a 1998 Ford Explorer?
How to Reset a Ford Explorer Computer
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
Can a car battery be disconnected while the engine is running?
Battery voltage MUST be maintained to the (PCM) and other modules; while the battery is disconnected. NEVER : disconnect the car battery; while the engine is running or the ignition key is turned on. Automotive Car Battery With Negative Cable Removed
What happens to steering angle sensor after battery disconnect?
The steering angle sensor will have to undergo a relearn procedure; following the battery disconnect. Replacing the car battery on some vehicles requires entering the new; battery info into the (PCM) with a scan tool.
What to look for when replacing a fuse on a Ford Explorer?
Before you replace or repair any electrical parts, check the appropriate fuses or circuit breakers. To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse.
How to disconnect a car battery to reset the computer?
Different cars will have different procedures, but with most, just driving the car will do the trick. If you use the baking soda mixture instead of cleaner, mix 1 tablespoon of baking soda into 1 cup of water. Thoroughly rinse the battery with clean water to remove all of the solution.
Battery voltage MUST be maintained to the (PCM) and other modules; while the battery is disconnected. NEVER : disconnect the car battery; while the engine is running or the ignition key is turned on. Automotive Car Battery With Negative Cable Removed
The steering angle sensor will have to undergo a relearn procedure; following the battery disconnect. Replacing the car battery on some vehicles requires entering the new; battery info into the (PCM) with a scan tool.
Can a car pass an emissions test after reconnecting the battery?
Warnings Use caution when disconnecting and reconnecting the battery. The emissions monitors in your vehicle will register being reset, so you will not pass emissions if you bring in a car immediately after resetting the codes. Drive your car for at least 200 miles (320 km) before bringing it in for an emissions test.
