How to choose the best clutch for your Mustang?

How to choose the best clutch for your Mustang?

When selecting a new or replacement clutch for your Mustang, be realistic about the power output & future goals. If you pick the right clutch the first time, you’ll be rewarded with good manners & a long service life.

Can a 2005 Mustang clutch fork be replaced?

Be sure to bleed 2005-2012 Mustang release bearings as per the service manual for OE applications & as per manufacturer recommendations for aftermarket units. If your clutch fork appears suspect upon disassembly, it is cheap insurance to go ahead & replace it.

What causes a clutch to slip on a Mustang?

Cause – A slipping clutch is often caused by: Incorrect clutch cable adjustment on your 1979-2004 Mustang. Incorrect hydraulic release bearing setup on your 2005-2012 Mustang. Oil or grease contamination of the disc friction facing. A used flywheel that was not resurfaced before installation of a new clutch.

What kind of transmission does a Mustang have?

If you drive a Mustang, more than likely it is equipped with some sort of manual transmission. Because of the widespread popularity of the Mustang & the sheer number of cars produced, the aftermarket is teeming with multiple choices in parts replacement, & this is especially true in the clutch department.

What kind of engine does a Ford Mustang have?

97-98 Mark VIII engine, complete with vacuum lines. 97-98 Mark VIII Upper fuel lines. * These disconnect in the passenger side wheel well of the Lincoln. 96+ Mustang GT wiring harness. 96-01 Mustang Cobra Exhaust manifolds. * I prefer the 99+ because they don’t have the air injection system that the 96-98 does.

Can you change the flywheel on a 4V Mustang?

Step 7. If you are using a manual transmission, bolt your flywheel and clutch to the 4v engine now. Be sure to install a new pilot bearing on the 4v engine. If your rear main seal is leaking, then this is a great time to change it.

What kind of wrenches do I need for a Ford Mustang?

Mustang GT clutch. 96-98 Mustang GT Pilot bearing. A set of car ramps. A decent set of wrenches with at least one 8, 10, 13, 15, and 18MM. And one 15/16th’s wrench for the motor mount bolts. I recommend having at least two 10, 13, and 15MM wrenches.