How do you reset the oil change light on a 2012 Ford Explorer?

How do you reset the oil change light on a 2012 Ford Explorer?

Turn the ignition to the RUN position, but don’t turn the vehicle on. Use the arrow buttons on the steering wheel menu to select SETTINGS and then CONVENIENCE. After that, You should be able to select OIL LIFE RESET and subsequently SET 10-100% will display. Use the arrows to get to 100% there and select it.

How do you check the oil life on a 2018 Ford Explorer?

Follow each of the following steps:

1. Turn on the ignition without starting the engine.
2. Go to the SETTINGS menu.
3. Scroll and select CONVENIENCE or VEHICLE.
4. Select OIL LIFE RESET.
5. Push and hold the OK button.
6. Turn the ignition off and start the engine to verify the indicator has been reset.

How to reset Ford Explorer oil change light?

How to Reset 2006–2010 Ford Explorer Oil Change Light: Imediately press button once to display “HOLD RESET IF NEW OIL” and release. Imediately press and hold button for 2 seconds until “OIL LIFE SET TO 100%” is displayed. Turn key off and then start your car and it should be reset.

How do I reset the oil change required message?

Press the “ Oil Change Reset ” button on the overhead Instrument panel for 5 seconds. After a brief countdown, the Oil Life will be reset. I hope this guide has helped you successfully reset the Oil Change Required message on your Ford Explorer.

Do you need to reset the oil change Minder light?

The engine oil life interval must be reset after performed the maintenance service on your vehicle. Follow the instructions below to reset the Engine Oil Change minder light on your Ford Explorer: Do not start the engine! Done! If playback doesn’t begin shortly, try restarting your device.

How can I Reset my oil life to 100%?

Press and hold “ Select/Reset ” until it says “ Oil Life Set to 100% “. Turn the ignition to the ON position. Do not start the engine. Press the “ Oil Change Reset ” button on the overhead Instrument panel for 5 seconds. After a brief countdown, the Oil Life will be reset.

How do you reset the oil change light on a Ford Explorer?

Ford Explorer Oil Change Light Reset Procedures: 2014-2015. Use the UP and DOWN arrow buttons to scroll to the Settings menu and press the RIGHT arrow to enter the submenu. Scroll to the Vehicle menu and press the RIGHT arrow. Scroll to the Oil Life Reset menu and press the OK button.

What kind of oil to used in a Ford Explorer?

• Genuine Ford Fluid XO-5W20-5Q3SP SAE 5W-20 Premium Synthetic Blend Motor Oil.
• provides a high degree
• Castrol 06240 EDGE Extended Performance 0W-20 Advanced Full Synthetic Motor Oil.

  Where is the oil filter located on a Ford Explorer?

  Slide under the front passenger side of the engine bay with the 15mm socket, a ratcheting wrench and a used oil catch container. The silver metal oil drain bolt is located on the rear edge of the silver metal oil pan facing the back of the vehicle. The oil filter is mounted vertically just in front of the oil pan.

  Does the Ford dealer have to use Motorcraft oil?

  Motorcraft motor oil can be found nearly anywhere, and it’s the only motor oil that a Ford dealership would and should use during a standard oil change. That’s because Motorcraft motor oil was specially formulated to operate with your Ford.