How can I replace the brake studs on my car?
How can I replace the brake studs on my car?
Remove the two bolts securing the brake caliper to the mounting bracket using a 3/8-inch drive socket. Lift the caliper off the rotor and suspend it from the spring using a suitable piece of wire. Remove the two bolts in the back of the brake caliper-mounting bracket using a 3/8-inch drive socket. Remove the rotor by pulling it off the hub.
What kind of bolts do you need to change brake pads?
Torx / Allen Set. Often the brake caliper bolts are held in place with Torx or Allen bolts. This depends on what your car has installed; therefore, it is better to verify you know what you need to change your brake pads. You can quickly identify what your car uses by looking at the two bolts on the caliper’s back.
What kind of brake drum does a 14 bolt have?
Last but not least, if you have a full-float 14 bolt axle you’ll want to figure out what kind of brake drum mount you have. The slide-on style of brake drum is found on newer 14 bolts (1988 onward), while the stud-mounted drum can be found on any 14 bolt produced between 1973 and 2000.
Where are the 14 bolt axle lugs located?
The axle bolts to the end of the hub, and on a full-float axle you can see a set of bolts at the axle end in addition to the 8 lugs you see on the wheel. Semi-float 14 bolt axles are not quite as rugged as full-float 14 bolt axles.
How do you put new brake pads on Windstar?
Use the caliper piston tool to push the caliper pistons back in so you can insert the new brake pads. Reinstall the retaining clip, slide the brake caliper back into place and bolt it back on. Repeat Steps 4 through 9 on the left side. Put the wheels and lug nuts back on, then jack the Windstar back up so you can remove the jack stands.
How do you put lug nuts back on Windstar?
Reinstall the retaining clip, slide the brake caliper back into place and bolt it back on. Repeat Steps 4 through 9 on the left side. Put the wheels and lug nuts back on, then jack the Windstar back up so you can remove the jack stands. Lower the Windstar back to the ground and re-torque the lug nuts to 75 ft.-lbs. with the torque wrench.
When did the Ford Windstar minivan come out?
Ford offered the Windstar minivan from the 1995 through the 2003 model years. Before undertaking the rear brake repair on your Windstar, pick up some OEM quality brake pads and rotors–avoid buying economy priced parts, as their wear life and performance are significantly less than professional grade parts.
How do you unbolt a rotor on a car?
Use the socket set to unbolt the caliper. Slide the caliper off the rotor and prop it up on the rear suspension, being careful not to let it hang from the brake line. Slip the rotor off and slip on the new one. Hold the new rotor in place by threading a lug nut on until hand tight.
