Is the choke shaft on a Holley 4180c?

The following illustrations and part #’s are from Ford’s master parts catalog. However, the drawing on the Illustration tab may be a generic Holley rather than specifically of a 4180C since it doesn’t show the bushing where the choke rod goes through the choke shaft’s bell crank.

Can a Ford Bronco be installed with Edelbrock?

Note: While this installation is performed on a classic Ford Bronco with a V-8 engine, most of the installation procedures and performance benefits of the Edelbrock Pro-Flo 4 apply to all vehicles.

What is idle mixture control on Holley Performance?

Many Holley performance carburetors are equipped with what is called four-hole or four-port idle mixture control. These carbs employ two more idle mixture screws on the secondary side of the carburetor. The adjustment procedure is exactly the same except that all four idle mixture screws are adjusted instead of just two.

What kind of EFI does Dorvillier Bronco have?

Dorvillier’s Bronco is no run-of-the-mill build. Gateway calls this their “Restomod Fuelie,” one of three different versions of assembly-line restorations that you can order. The Fuelie is the hot rod version powered by a Ford 347-cubic-inch stroker with EFI.

Note: While this installation is performed on a classic Ford Bronco with a V-8 engine, most of the installation procedures and performance benefits of the Edelbrock Pro-Flo 4 apply to all vehicles.

What kind of power valve does Holley use?

Holley power valves are known for failure, there are some modifications available, one of which is a ball check valve that is inserted in the throttle body to prevent a backfire from rupturing the diaphragm. Holley has discontinued the 2 stage power valve used in these carburetors, but Motorcraft ones may still be available and will fit.

Is the choke shaft on a Holley 4180c?