When to replace the cv shaft and output shaft seal?
When to replace the cv shaft and output shaft seal?
Regardless of whether the axle shaft is being replaced or not, the inner shaft (or differential) seal should be replaced. Older, high-mileage cars may have seal leakage due to dry rot, hardening with age, or slight damage during a shaft removal or installation job.
How to replace a front axle shaft seal?
If you have ever owned a GM four wheel drive vehicle then there is a good chance you have had a front axle shaft seal leak. We replaced the RH output shaft seal on a Tahoe but it is the same for Silverado, Sierra,Suburban and Yukon. Part one shows details on the tear down and part two with guide you through the reassembly. Loading…
How much does it cost to replace oil seal on CV axle?
A lot of seal replacement jobs could have been avoided if the installer of the new axle bothered to replace the oil seal with a new one. The part is around $10 and only adds a few minutes to the job. Either a small pry bar or seal removal tool will work.
Do you need to replace the CV seal on a Subaru?
Toyota CV snap rings tend to be stronger than snap rings found in other cars (i.e., Honda, Nissan, etc.—Subaru uses compression pins to hold their inner CV axles, but that’s another story). Seal replacement is highly recommended.
What to do when you remove axle from CV joint?
It’s normal for some transmission fluid to leak out as you remove the axle from the cv joint. You should put down a catch pan. On your vehicle, the axle may have to pass through an enclose piece called a wishbone before it’s completely free. You can remove the band from the inner boot to help the old axle pass through.
If you have ever owned a GM four wheel drive vehicle then there is a good chance you have had a front axle shaft seal leak. We replaced the RH output shaft seal on a Tahoe but it is the same for Silverado, Sierra,Suburban and Yukon. Part one shows details on the tear down and part two with guide you through the reassembly. Loading…
How long does it take to change a CV axle?
If you don’t run into problems like a seized axle or joint, it should be done in an hour or less. If you have an issue, like a part that’s rusted and fused to the hub (like I recently had)]
How do you remove the hub from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower.
