Why does my Chevy Silverado make a clicking noise?

I have the same clicking noise on a 2005 with a 5.3. The stethoscope tells me it is inside the oil pan near the back. It is directly related to RPM. Oil pressure is fine and I drive it everyday but the noise is irritating 84 people found this helpful. Guys! Ive had the same problem for quite a while.

Why is my lifter making a loud knocking noise?

The noise is camshaft/lifter roller damage caused by the plastic lifter guide worn on one lifter allowing the lifter to ever so slightly rotate causing the roller to dig into the cam lobe and gaulding both surfaces.

What’s the knocking noise coming from MY Suburban?

I recently ran into this same knocking/ ticking issue coming from my 2005 Suburban, 5.3 Vortec. After countless hours of research, multiple engine flushes, oil change, air filter, valve adjustment…etc etc etc…my solution and problem were relatively simple.

Are there any issues with my Chevy Silverado?

Never had issues as long as I treated them right. the 57 Ford refused to break, the 51 Plymouth kept spinning rod bearings. Beat you vehicle, and keep shelling out money. 14 people found this helpful.

Why are there so many collapsed lifters on Silverado?

If the problem was collapsed lifters and they were replaced and the noise still exists – two possibilities: either they didn’t replace them; or they did replace them but they did not fix the underlying cause that causes the lifters to collapse.

Why does my Vortec valve lifter make a ticking sound?

This ticking sound is caused by the valve lifters, which are filled with oil during engine operation. When your engine sits, the oil can seep out of the lifters. When this happens, the lifter will tick at start-up until it refills with engine oil. Ticking lifters are not dangerous.

What kind of noise does a noisy lifter make?

The noise can vary like ticking, tapping, clicking and it can last from few seconds after starting to till the entire time your engine is running. Depending upon the type of noise and it’s span, we can decide how serious the noisy lifter is.

What do I do if my Chevy Silverado makes a ticking noise?

Once the noisy cylinders have been located, the head will have to come off next. This involves removing the intake, exhaust manifolds, rockers and stands, sensors and wiring, accessories, etc. Actually it isn’t that bad of a job to take one of these engines apart, and I always do this with the engine still in the truck.

What kind of car makes a loud knocking noise?

I have an 06 1500 Z71 4wd with 73k miles. I’ve put 8,500 miles on it and it just started knocking. Started out light and has gotten worse. Does it whether it is cold or hot.

Why does my oil pump make a loud knocking noise?

If you look at your oil pressure and it reads anything under 40 at cold start idle this means your oil pump screen has one of two things: 1) It is clogged and needs to be cleaned, these things are pure metal so a costly replacement wouldn’t be worth it, a simple clean will suffice.

Why does my GMC Jimmy make a clicking sound?

Googled it cuz a friend of mine has a GMC Jimmy with the same problem. It looks like the issue is a “blend door actuator” read on: I have a 1994 Chevy C-1500 that is making a clicking sound behind the glove box area,what might that be?

What causes a noise when you brake on a Chevy?

Brake Chatter: Warped or improperly finished rotors will cause this noise. Brakes that Grab: If there is oil, brake fluid or grease on the pads, they will slip and then grab hold. You may feel your Chevy jerk when you brake. Check your pads for any type of contamination.

Why does my truck make a clicking sound when I turn it off?

The sound lasts for about 10 seconds and then stops. When I turn the truck off, it happens again for about 10 seconds. The problem didn’t occur often until I had the AC system recharged lately. What do you think the problem is? If I need to replace the blower motor, how can I remove the plasting cowling in front of it without cutting it out?

What happens if the speakers on my Chevy truck go bad?

Most of the time, broken speakers mean a lack of convenient entertainment while driving, but they could potentially cause safety issues, as they could prevent you from using OnStar if all of them were to go. The way to fix this issue is to replace the speakers. If you want a quick fix, you can buy a cheap set of speakers.

Why does my front suspension make a popping noise?

When CV joints start to wear, they will bind up on acceleration especially in a turn. This causes a popping sound in the front suspension that can transfer to the vehicle. – Learn More

What to do if your car is making a popping noise?

To check for this condition use a flashlight to view the upper and lower control arm bushings. If any rubber is missing or pushed out of the side, they must be replaced.

While driving at various speeds, the vehicle misfired and a small tick noise was heard under the hood. Over time, the tick noise increased in volume and became more of a knocking noise. The vehicle was taken to a certified mechanic who diagnosed that the cam shaft, rods, and lifters needed be replaced.

Why does my Silverado have a clunk when I stop?

2008 silverado 2wd hits me with a clunk when i come to stops. feels like someone comes up from behing and bumps me. or like the transmission is downshifting after i stop. what could this be? You can’t post conmments that contain an email address. An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

How to fix driveline clunk in Chevy truck?

My truck is a NNBS 2008 crew cab and it was doing the clunk. I’ve also heard that marine grease works a little better because it’s thicker. dalejrfan88 wrote: The fix for my 03 was dipping a racquetball in Vaseline and putting it in drive shaft to soak up the extra lash/play. Then it was silent.

Are there any problems with my Chevy Silverado?

Chevrolet Silverado owners have reported 18 problems related to engine clicking and tapping noises (under the engine and engine cooling category). The most recently reported issues are listed below. The contact owns a 2008 Chevrolet Silverado.

Why does my Chevy Silverado make a clunking noise?

Some owners have said that fuel sloshing in the fuel tank makes a clunking noise. This should be a minor noise, but if you have really good ears, you can check. The fuel tank or tanks will need to be half-full or less.

What to do about rear end clunk in Chevy Silverado?

Dealer replaced the slip yoke and a grease kit under warranty and problem is solved. You can’t post conmments that contain an email address. An expert who has achieved level 1. An expert whose answer got voted for 2 times.

When does the clunk come back in my truck?

Enjoy your truck with extremely less of a clunk or eliminated for about 8-10 month. Repeat if the clunk come back. Last edited by starspangled6.0 on Feb 11 2012, 9:07pm, edited 1 time in total.

Is it annoying to come to a stop and feel the clunk?

As you know, it is extremely annoying to come to a stop and feel that Chevy patented clunk just like someone has just rear-ended you. Well, after several online posts, I finally decided to do my truck.

I have recently noticed a clicking noise from the front differential on my 2000 Chevrolet Silverado when traveling at low speeds (under 10 MPH, but I’m sure it’s always there, but it’s too fast/too much road noise which makes it impossible to hear at faster speeds).

Where does the clicking noise come from on a 4 wheel drive car?

I know it’s coming from the front, and I even removed the tire and the driver’s axleshaft and rotated the shaft coming out of the front differential directly and I still heard/felt the clicking noise from the front differential. Partially locked 4 wheel drive/bad vacuum solenoid.

Why does the passenger window click but not roll?

Passenger window does not work. switch makes a “click” type noise but nothing happens with the window. The same sound you get when the windows is all the way up but try to raise it more. I have not opened it up yet to check any voltage to the motor, but I’m thinking it’s a bad motor not switch.

Where is the Lt Dr circuit breaker on a Chevy truck?

The circuit breaker is located in the instrument panel fuse block located on the driver side edge of the instrument panel. Look for the LT DR circuit breaker. Should only have two connections, use a meter to measure resistance across the terminals and it should read close to 0 ohms or read a short.

Where does the clicking come from on a GM Truck?

The clicking starts when I crank the truck up and last about 15-20 seconds.I hear the same clicking when I turn the truck off and it lasts about the same time.Like I said it is coming from behind the glove box above the heater core.The heater core has not shown me signs of it being bad,no leaking,and no foggy windows.

What does clicking from pass side low dash mean?

Take some pics if you can. Always nice to have as much info as possible on a repair. It will help those who follow in your footsteps.:biggrin:

Why does my car make clunking noise when I make a turn?

Noise: Banging or clunking while making a turn, backing up, or rapid deceleration (like on a freeway off-ramp). Noise gets worse in warmer weather Cause: Posi chatter due to improper lubrication; worn clutches or spider gears; improper assembly Noise:Banging, crunching, or popping while making a turn. Noise not affected by temperature

Why does my car make a knocking noise when I Turn on the engine?

A damaged or worn connecting rod bearing will produce knock under all speeds. During the early stages of wear, connecting rod noise may be confused with piston slap or loose wrist pins. Connecting rod knock noise increases in volume with engine speed and is at its loudest on deceleration.

Where does the lifter sound come from on a Chevy Silverado?

You can hear lifter click best around the top of the engine, and isolate the noise with a stethoscope against the valve cover. It will occur at idle and increases as you rev the engine, continuing even when the engine is warm. Valve lifter noise is detrimental and should be addressed quickly.

Why does my Cummins engine make clicking noises?

If the voltmeter doesn’t show any voltage it means that the relay is not working. This could be a faulty relay or wiring to it from the start button. Check for dirty connections on the copper link from the solenoid output stud to the starter fields. I have also seen this link break on Cummins engines.

Why does my car make a ticking noise when I accelerate?

Rod knock could be the possible reason for a major engine issue. When the bearing connected to the rod wears off or gets damaged, the rod knocks around the crankshaft and creates a metal-to-metal sound. You will hear a rhythmic, loud ticking noise in engine when accelerating.

What makes a Chevy Silverado make a knocking noise?

For the first 30 to 60 seconds after a cold start, the short-skirted pistons rock inside the cylinders and slap against the cylinder walls, sounding rather like a diesel engine. The knocking can be heard around the top of the engine, but is much louder if you listen in the front wheel wells or beneath the truck.

What causes a loud clicking noise during acceleration?

Noise: Banging or heavy clicking every two to three feet during acceleration and deceleration Cause: Damaged or broken pinion gear tooth or teeth Noise: Banging or heavy clicking every two to three feet during acceleration or deceleration, but not both

Why is the clicking on my Chevy Tahoe not working?

The clicking is usually a solenoid (when battery voltage is strong enough, it holds the solenoid down to supply starter with full voltage.) So, Battery may be old, or damaged or out of water, it needs to be checked with a hydrometer or battery tester (each individual cell).

What to do if your Chevy Suburban won’t start?

If you have a model of Suburban which only has a key fob with start/stop button and no place to insert a key, then try placing your key fob as close to the start/stop button as you can and then start the vehicle.

What causes a GMC truck to turn over but not start?

If the engine starts up normally after doing that, it means that fuel pressure is bleeding off and the fuel pump needs to prime the lines before it can start. It can bleed off from one of two places. 1. Fuel pressure regulator has an internal leak, and fuel is bleeding off back to the tank though the return line. 2.

Why does my Chevy Silverado want to turn over?

Truck wants to turn over but will act as if is starving for fuel,wait ten minutes, it start. Been happening frequently lately. I also was told it was the security system Will turn key and it is like no power from battery to starter, but have lights, radio, etc. Turn key again or sometimes multiple times, to no avail.

Why does my starter click when the key is turned on?

Hope this helps!!! Nope it’s not a dead battery the starter sounds like it wants to go but all it does is click. it almost sounds like what my old s10 did when the starter is over heated. what does a starter go for?

What should I do if my anti lock brakes are not working?

If you’re having trouble with your car’s ABS, look into it ASAP regardless. A malfunctioning system can have worse consequences than just lock-ups. It may pulse your brakes when you don’t need it to or disable other safety features on your car. Your ABS light is on.

Why does my car have an anti lock system?

Modern vehicles have what is known as an anti-lock braking system. The purpose of this system is to keep the driver safe by preventing the wheels from locking up as you apply the brakes.

What to do if your power steering pump is making noise?

If your power steering pump is making noise and you can’t get a new one, the best thing to do will be to keep it full of fluid to make sure no further damage occurs. Sometimes power steering pumps can get noise and last for a long time continuing to make that noise.

How to troubleshoot Chevy Silverado ABS system problems?

Remove the fuse for the ABS system with a fuse puller located in the fuse box cover. Check the fuse to make sure that it is not blown. If it is, you’ll need to replace it with another fuse of the same amperage. Look behind each wheel of the Silverado. On the back of the wheel hub are the wires for the ABS system.

Why is my abs light not working on my Chevy Cobalt?

The antilock brake system runs through the ABS module. This module physically controls the anti-lock brake system If it becomes damaged, and can no longer control all four brakes, the ABS light will activate. Typically, corrosion is the most common reason why the module fails.

What can I do about my Chevy brake noise?

You should put new pads on your Chevy and replace or repair the rotors. You could add shims, use a brake noise aerosol, or brake grease to the backs of the pads to dampen the noise. Brake Chatter: Warped or improperly finished rotors will cause this noise.

Why is the check valve on my vacuum not working?

This is due to the excess pressure inside the master cylinder, which the check valve is designed to regulate. The inconsistency of the brake pedal is a warning sign that a potential safety issue exists with the brakes and should immediately be inspected by a certified mechanic. 2.

Why does my Chevy Silverado make a clicking noise?