What is code 1409?
What is code 1409?
Error Code P1409 is defined as EGR Vacuum Regulator Solenoid Circuit Malfunction. This error code refers to a test to check the electrical function of the EGRVR (Exhaust Gas Recirculation Vacuum Regulator) solenoid. For the test to be completed, the EGR must be enabled.
Why does my Ford p1409 code not work?
The test fails when the EGR VR circuit voltage is either too high or too low when compared to the expected voltage range. The EGR system must be enabled for the test to be completed. Need more information on how to fix the P1409 FORD code?
Why is my vacuum regulator set to code 1409?
The code 1409 in most case is set due to a bad EGR control solenoid. Replacing the defective EGR control solenoid will likely correct your concern. To remove the EGR valve, you should first remove battery ground cable. Then, disconnect the EGR vacuum regulator valve. Next, disconnect the electrical connector, then disconnect the vacuum hoses.
What’s the trouble code for a Ford engine?
Trouble Code. Fault Location. Probable Cause. P0171. Fuel trim (FT) system too lean, bank 1. Intake/exhaust leak, AIR system, MAFNAF sensor, fuel pressure/pump, injector (s), HO2S. P0300. Random Cylinder Misfire (Cylinder Not Specified) Spark plug (s), HT lead (s), injector (s), ignition coil (s), low compression, wiring.
How much does it cost to test Ford p1409?
The cost of diagnosing the P1409 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. This test checks the electrical function of the Exhaust Gas Recirculation Vacuum Regulator ( EGR VR) solenoid.
The code 1409 in most case is set due to a bad EGR control solenoid. Replacing the defective EGR control solenoid will likely correct your concern. To remove the EGR valve, you should first remove battery ground cable. Then, disconnect the EGR vacuum regulator valve. Next, disconnect the electrical connector, then disconnect the vacuum hoses.
The test fails when the EGR VR circuit voltage is either too high or too low when compared to the expected voltage range. The EGR system must be enabled for the test to be completed. Need more information on how to fix the P1409 FORD code?
The cost of diagnosing the P1409 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. This test checks the electrical function of the Exhaust Gas Recirculation Vacuum Regulator ( EGR VR) solenoid.
What is the code for Ford diagnostic trouble?
Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER Test Cannot Be Completed P1039 Vehicle Speed Signal Missing or Improper P1051 Brake Switch Signal Missing or Improper P1100 Mass Air Flow Sensor Intermittent
